AT&T 145 user manual Set the Dial Mode switch

Page 5

INSTALLATION

5.Set the Dial Mode switch

This product comes set in the TONE mode. Make sure you choose the correct dialing method (TONE/PULSE); touch tone dialing will not work if you have dial pulse service.

6.Connect handset to telephone base Connect one end of the coiled handset cord to

the base. Plug the other end into the handset. Then hang up the phone.

7.Check for dial tone

Lift the handset and listen for a dial tone. If you can’t hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.

Line Jack

Wall Jack

Handset

Jack

Figure 4

NOTE: If you cannot fit the base onto the wall jack plate, remove the top two non-slip feet.

4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Design Line Telephone Dial Mode InstallationTABLE/DESK Installation Install telephone base on wall jack Wall InstallationReverse the handset tab Fill in directory cardSet the Dial Mode switch Operation Memory Memory FeaturesSpeed Dialing Memory EraseNo Dial Tone Case of DifficultyCalls Cannot Be Dialed, or Are Dialed Slowly Telephone Does Not Ring
Top Page Image Contents