Jensen KT2012 OFF/LO/HI Ringer Switch, Storing and Redialing Numbers in the SPEED-DIAL Memory

BASIC OPERATIONS (CONTINUED) BASIC OPERATIONS (CONTINUED)

OFF/LO/HI RINGER SWITCH

Slide the OFF/LO/HI Ringer switch to the HI or LO position to turn the ringer on.

Slide the OFF/LO/HI Ringer switch to the OFF position to turn the ringer off.

If you are in a Pulse dialing area you may still take advantage of touch-tone services after dialing to respond to touch-tone prompts. To do this, press the */TONE button to temporarily change the dialing mode from Pulse to Tone after dialing in the Pulse mode. This will enable Pulse users to access touch-tone services. It will revert back to Pulse after hanging up.

If you subscribe to Call Waiting through your local phone company, and you receive another phone call. Simply press the FLASH button to answer the new call. Press the FLASH button again to return to the original call.

Slide the TONE/PULSE switch to TONE or PULSE to match the service provided on your telephone line. If you are not sure of your service, please contact your telephone company.

To increase/decrease the handset’s volume, slide the RECEIVER Volume switch to the NORMAL (N) or HIGH (H) position.

STORING AND REDIALING NUMBERS IN THE SPEED-DIAL MEMORY

This telephone has ten speed-dial memories to store up to 10 of your most frequently called numbers for easy two-touch redialing. Each of the 10 memories can store numbers of up to 16 digits. HOWEVER, ONLY THE LAST 14 DIGITS WILL APPEAR IN THE DISPLAY

IMPORTANT:You must lift the handset from the cradle to store numbers in the memory. After a few seconds off the cradle, you will hear the “off the hook/hang up” warning signal from the phone company. Therefore, if you are going to store more than one number at a time, please disconnect the straight cord from the wall jack to avoid the “off the hook/hang up” warning signal. REMEMBER TO RECONNECT THE STRAIGHT CORD AFTER YOU FINISH STORING YOUR NUMBERS.

TO STORE

Press the REDIAL button to automatically redial the last number dialed. NOTE:Please note that only the last number you called on this handset can be stored in the Redial memory.

Press the FLASH button to hang up the phone without having to return it to the base. If you subscribe to call waiting, FLASH button is also used to switch between calls.

Lift the handset and press the STORE button. The “STORE” indicator will appear in the display.

Use the number keys to enter the first area code and number that you wish to store. Remember to enter the number “1” if necessary. The numbers will appear in the display as you dial them. NOTE:If you make a mistake while entering the number, depress the Hook switch to clear the display and then start with step 1 again.

13

14