Optional Postal Lock, Optional Color Cctv Camera

Optional Postal Lock

A postal lock can be installed in the AE-1000 Entry System to provide keyed access for the postal service. The AE-1000 case is designed to accept a U.S. Postal Service postal lock. When the postal lock is engaged, the programmed output relay will activate.

Postal Lock Installation

1.Remove the four locknuts that retain the postal lock switch plate (above the speaker on the AE-1000 faceplate).

2.Remove the switch plate hole cover plate, and block from the four studs. The hole cover plate and block will not be used and can be discarded.

3.Install the postal lock assembly onto the four studs. The postal lock’s moving plunger should point towards the middle of the faceplate (see ﬁ gure).

4.Replace the postal lock switch plate with the microswitch oriented inward where it will be pressed by the postal lock’s moving plunger (see ﬁ gure).

5.Secure the postal lock and switch plate with the four locknuts.

✦NOTE: Be sure the postal lock’s plunger actuates the microswitch. Adjust the switch plate and the postal lock then test the action until the microswitch fully actuates.

1REMOVE LOCKNUTS

3INSTALL POSTAL LOCK

PLUNGER POINTS

TO LEFT

2REMOVE PLATE

4REPLACE PLATE WITH THE MICROSWITCH TOWARDS THE FRONT OF THE CABINET, REPLACE LOCKNUTS

6.Tighten the four locknuts after the adjustment and testing is complete.

7.When programming the system, set the postal lock option to activate the desired relay output.

NOTE: BE SURE THE POSTAL LOCK'S PLUNGER ACTUATES THE MICROSWITCH. ADJUST THE SWITCH PLATE AND THE POSTAL LOCK THEN TEST THE ACTION UNTIL THE MICROSWITCH FULLY ACTUATES

Optional Color CCTV Camera

Linear’s Model CCM-1 (P/N ACP00904) CCTV camera can be installed inside the AE-1000 Entry System. The camera provides a video signal for viewing the area in front of the entry system.

The CAMERA connector is used to connect the camera to the AE-1000. The 4-conductor cable routes power to, and video from the camera. The VIDEO jack is the camera output for connection to a video cable with a Type “BNC” connector. Up to 400 feet of 75-ohm RG-59 video cable can be used. Longer cable runs may require the use of a video ampliﬁ er.

Camera Installation

1.Remove the two locknuts and the cover plate from the camera mounting studs above the keyswitch on the AE-1000 faceplate.

2.Mount the camera assembly on the two studs, with the alignment hole in the camera bracket towards the top. Secure the camera with the two locknuts.

3.Connect the camera’s cable to the AE-1000’s CAMERA connector.

4.Connect the video cable to the AE-1000’s VIDEO connector.

5.Connect the other end of the video cable to the viewing monitor or the video distribution system.

1 REMOVE PLATE RETAINING NUTS

2 REMOVE THE PLATE

COVER PLATE

3 INSTALL THE GASKET

4 REMOVE THE LENS CAP

	GASKET
	5 ATTACH CAMERA WITH TWO NUTS	6
	5 ATTACH CAMERA WITH TWO NUTS	CONNECT
		CONNECT
		CAMERA
	HOLE	WIRING
	ON TOP	HARNESS
		7
		CONNECT
		VIDEO
		CABLE