SECO-LARM USA DP-121Q manual Installing a Second Monitor, Secondary Monitor Detail

ENFORCER VIDEO DOOR PHONE

6.Plug the AC Power Adapter’s cable into the “Power” socket on the back of the monitor.

7.Run the wires going to the camera under the plastic hooks on the back of the monitor so that any tension on them will not be directly transferred to the plugs or sockets.

8.Plug the AC power adapter into a 120VAC socket.

9.Test the monitor and camera unit by pressing the camera button. The image in front of the camera should be displayed clearly.

Figure 2 – Back of

Primary Monitor Detail

Monitor	Not
2	Used
Camera	Camera
2	1
Power

Camera 2 and Monitor 2 sockets are used only with optional additional monitor and camera.

Installing a Second Monitor:	Figure 3 – Back of
10. If using a secondary monitor, follow steps	Secondary Monitor Detail
1-4 on page 4.
11. Plug the brown 4-pin plastic connector from	Main
	Monitor
the camera into the “Main Monitor” socket
(see Figure 3).
NOTE: There will be an unused socket on
the back of the secondary monitor.	Not	Power
12. Follow steps 6-9 above to complete the	Used
installation

SECO-LARM U.S.A., Inc. 5