SECO-LARM USA DP-121Q manual Installation camera, Camera Mounting Location

ENFORCER VIDEO DOOR PHONE

Installation (camera):

1. Position the camera so the area to be monitored is easily visible, typically 5 feet (150cm) above the ground (see Figure 3). Do not position the camera in direct sunlight or where it will be exposed directly to rain or snow.

2.Cut a hole large enough to run the 22AWG

4-conductor wire through the wall to where the camera unit is to be mounted. If using a locking device, the wires used to control the device must also be run through this hole.

3.Run the 22AWG 4-conductor wire from the camera location to where the monitor is mounted. The maximum wiring distance is 165’ (50m) (see Wiring Diagram, page 8).

4.Using the 4 included screws and 4 screw anchors, attach the camera mounting bracket to the wall (see Figure 4).

5.Connect the wires coming from the monitor to the proper terminals E1 thorough E4 on the back of the camera (see Figure 5).

6.If the Door Phone will control a locking device, connect the wires coming from the locking device to the relay output terminals K1 and K2 on the back of the camera (see the Sample Application on page 11).

7.Set the desired camera angle up and down by moving the tilt adjustment in the opposite direction.

8.Push the tab on top of the camera into the top of the bracket. Make sure that no wires are preventing the camera from seating properly in the bracket. Pull the slide-out cover to expose the hidden screw location.

9.Secure the camera to the mounting bracket with the included camera screw. Close the cover at the bottom of the camera to conceal the camera screw.

Figure 4 – Camera Mounting Location

5’

(150 cm)

DirectRain

Sunlight Snow

Figure 5 – Camera and

Mounting Bracket

The tab on top of the camera slides in first.

Secure the camera to the bracket with the hidden camera screw underneath this slide-out cover.

Figure 6 – Rear of

Camera Unit

Tilt Adjustment

6 SECO-LARM U.S.A., Inc.