Graco Inc 249617 Motor Replacement, Replacing Motor Fan, Removal, Installation, Removing Pulley

Motor Replacement

Removal

1.Relieve pressure, page 5.

2.Remove screws (79) and washers (78) and belt cover (67).

3.Remove belt (19), page 20.

4.Remove screws (21), washers (70) and nuts (10) securing motor (5) to frame.

5.Remove motor (5) from frame.

Replacing Motor Fan

Removal

a.Loosen and remove bolts (86) on front of fan (14).

b.Pull fan (14) off small pulley (6).

Installation

a.Position new fan (14) over small pulley (6).

b.Replace bolts (86) and tighten securely.Torque to 125 + 10 in-lb (14.1 + 1.1 N.m).

Motor Replacement

Removing Pulley (6)

NOTE: This procedure is only necessary if you are replacing the motor. When you install a new motor you reuse the existing pulley.

Removal

a.Loosen set screw (87) located on the side of the pulley (6).

b.Remove large bolt (24) in the center of pulley

(6).

c.Pull pulley (6) off motor (5).

Installation

a.Position new pulley (6) on motor (5).

b.Install large bolt (24) and washer (65) in center of pulley (6). Torque to 125 + 10 in-lb (14.1 + 1.1 N.m).

c.Tighten set screw (87). Torque to 60 + 2 in-lb (25.4 N.m).

Installation

1.Install motor (5) in frame.

2.Replace all screws (21), washers (70) and nuts (10). Tighten securely.

3.Install belt (19) over pulleys (4, 6), page 20.

4.Replace belt cover (67) and screws (79) and wash- ers (78) (2 each side). Using a wrench tighten bolts. Torque to 25-30 in-lb (2.8-3.4 N.m).

311283D 29