M&S Systems DMC3-4 installation instructions MC960 Power Amp Installation

Figure 19 - Speaker installation

Figure 17 - Power amp wiring

dmc3-4

MC960 Power Amp Installation

Run the MS7XSC cable
		MS3XSC
from the dmc1H or
dmc1HC wall housing to
the remote power	DMC 1H
amplifier.

Run the MS3XSC cable from the remote amplifier to each volume

MS3XSC control (use the SVC96 for stereo or the MVC1 for mono). From each volume control, run the MS2SXSC to each respective speaker as shown in Figure 17.

		The remote power amplifier should be located in a closet or
	MS7XSC
		utility closet and should be located within 6 feet of a
		standard NEMA 5-15R 120VAC receptacle. Install a 1-gang
		and a 2-gang box	MC960PA
Figure 18 - Power		at the location for
amp installation		the remote
		amplifier on a

stud. Allocate the 1-gang and 2- gang boxes relative to one another as shown in Figure 18. Run all MS3XSC cables from the volume controls to the remote amplifier’s 2-gang box.

Run the MS7XSC cable from the dmc3-4 to the remote amplifier’s 1-gang box. The remote amplifier is designed to

mount over the 1-gang and 2-gang boxes on a single stud. Note: The speaker cables CANNOT be located in the same gang box used for 120VAC wiring.

Each pair of stereo or mono music speakers is controlled by a single volume control. The volume controls install in a standard single gang box. Run a MS3XSC cable from each volume control location to the remote

www.mssystems.com 800.421.1587

Page 19