M&S Systems DMC3-4 installation instructions Test the System, Speaker Panel Placement

Page 21

dmc3-4

Test the System

After all connections have been made, insert the dmc3-4 power plug into TE5C transformer and secure the master to the wall housing using the 2 screws provided. If using the dmc1F, dmc1FC or dmc1FM frame with a dmc1CD player, install the master unit over the frame. Do not over tighten the screws as the plastic may distort or crack. Install the speaker panel on the master as shown in Figure 20.

Please be careful to only apply pressure on the speaker panel at the corners and not in the middle. Check all functions by following the guidelines in the Owners Manual shipped with the master unit. If any difficulties are encountered, recheck all connections. If after reviewing these instructions you are unable to resolve any problems, contact technical support at 1-800-421-1587.

Figure 20 - Speaker Panel Placement

www.mssystems.com 800.421.1587

Page 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Dmc3-4 Installation Instructions Introduction Instructions Dmc3-4 Dmc3-4 Dmc3-4 Installation Overview Develop the Job Estimate Removing the Old System Installing the Wall HousingTransformer 120VAC/60Hz run Replacing the Room Stations Transformer placementNuTone Wire IW3 or 3-Wire Dmc3-4 Equivalent Patio Speakers External Music Source Door StationsInstalling the dmc1CD player Installing the Chime ModuleHand wire thick Installing the dmc3-4Chime Connecting the AntennaWireless Remote Control Connection Power MC960 Power Amp InstallationDoor Release Options Door or Gate Release MechanismPanic Interface with Security System Test the System Speaker Panel PlacementAppendix a NuTone Systems Appendix B M&S Systems Systems 2-Year Warranty
Top Page Image Contents