models NM200WH • NM200AL
NM200 series system installation
Page
read and save these instructions
caution
to reduce the risk of fire, electric shock, or injury to persons, observe the following:
1.Read all instructions carefully before installing or using the NM200 System.
2.The NM200 must be installed by a qualified dealer or installer, and must conform to all local building and electrical codes.
3.For continued protection against risk of fire replace the fuse in the power switch module only with the same type 3 Amp,
250 Volt fuse.
4.Adhere to all warnings on the NM200 and in these instructions. Follow all operating and installation instructions.
warning 
These installation and servicing instructions are for use by qualified personnel only. To reduce the risk of electric shock, do not perform any servicing otherthanthat contained in the operating instructions unless you are qualified to do so.
•Do not attempt to service the NM200 yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
•Locate the system away from heat sources such as radiators, heat registers, stoves, or other heat producing products.
•Do not locate the NM200 master or remote stations in an outside wall.
•Do not locate the NM200 to moisture. Doing so can create fire or shock hazards and void the warranty.
•Do not place the NM200 master or remote stations in any wall cavity with any other electrical wiring in the cavity.
•Install the NM200 system after the application of the wall covering material.
•Do not expose the outdoor remote station speakers to significant water contact. The outdoor remote speakers are weatherproof but not water proof. Continuous direct water exposure will cause system problems.
•Do not connect CAT5 wire if you are unsure of its termination point. Connecting a door station to a remote station may result in system damage.
•Do ensure that all
•Do not splice cables. Splices are unreliable and defeat signal isolation properties of the cable.
•Do not attach devices unauthorized for use with this system. Authorized devices include:
Audio components connected via a line level input NC300
•If extra cables have been run for future speaker additions, care must be taken to ensure these cables are not connected to the NM200 master unit.
•Do not
•Use only NuTone certified replacement parts and have them installed by a qualified dealer or installer. Unauthorized substitutions can result in fire, electric shock, or other hazards.
•Upon completion of any service or product repair, have the dealer or installer conduct a safety check to ensure the system is in proper operating condition.
•Use only a damp cloth to clean the NM200 master and remote stations. Do not use liquid cleaners or aerosol cleaners.
installation
To ensure that the homeowner receives the
The installation should be made after the application of wall covering material.
Tools required:
•#2 Phillips screwdriver
•Standard flat head screwdriver
•Wire stripper/cutter
•Level
Installing the Remote Stations
Collect all the connectors included in the remote station packages and place them in the master