models NM200WH • NM200AL
Antenna Connection
Connect the FM dipole coax antenna lead “F” connector to the FM 75 Ohm “F” connector on the NM200 master as shown in the previous figure. Connect the orange AM antenna wire to the AM terminal on the master.
Door Release Connection
To use the door release, connect the 18 gauge low volt- age cables from the remote power transformer and the door release striker. The 24 Volt/2 Amp dry contact switch closure may also be used for home automation or security panel panic alarm interface.
Note: The door release operation may only be used for one type of function per application.
External Audio Sources
Plug in the RCA™ phono plugs to the AUX jacks as marked for the source audio equipment.
Page
Powering Up The NM200
After all connections have been made, insert the power plug into the transformer and secure the master to the
Please be careful to only apply pressure on the speaker panel at the corners and not in the middle. Check all functions by following the guidelines in the Owners Manual shipped with the master unit. If any difficulties are encountered, recheck all connections. If after reviewing these instructions and you are unable to resolve any problems, contact technical support at 1-