
0210
GH Series Installation Manual Supplement
Programming Guide for Assigning Tenant Station ID Numbers
IMPORTANT:
Follow these instructions carefully when programming the GH entrance panel to call tenant stations.
Ensure that all units are installed and wired properly. If your system includes the
module, program the resident information (tenant names and room numbers) before assigning the ID’s.
1.Turn the power switch on the GH-BC to the ON position.
2.At the Entrance Panel, loosen the screw on the bottom of the front frame using the supplied #10 spanner tool (part # 262230) and remove the front panel. (Note: a #10 spanner bit is available at most hardware stores.)
3.To put the system into program mode, lift the rubber cap on the
4.After the
5.For the GH
Forthe
6.Press the talk button again on the tenant station to turn that unit off. If this is your first time programming the system, it is recommended to exit programming and test the station that you just programmed. Press the program button on the
7.If there is more than one tenant station in a unit, each station will have to be assigned to the entry panel using the procedure above. The entry panel will emit 2 blip tones for the second unit, 3 blip tones for the third unit,and 4 blip tones for the fourth unit that is programmed for entry from the panel. 5 blip tones indicates a programming error. If 5 blip tones are heard, you’ll need to clear the program for the tenant and entry panel address. See page. 3
- 2 -