3M Model | Programming the System |
Error Message
! E R R O R !
NO COMMUNICATION
The system will display one error message: No Communication.
The message occurs when there is no communications between the Selector and Controller. To correct this:
1.Be sure Controller is powered on.
2.Be sure pins 2 and 3 of J22 on the Controller are connected to pins 2 and 3 of J8 on the Selector. Polarity must be correct.
Parameter Selection
01:Selector ID # {01}
02:Max Stations {16}
03:Alert Volume {08}
04:Alert Type {Chime}
05:VOX Enable {Off}
06:VOX Sensitive {15}
Memorized parameters are given below. These parameters are stored in the EEPROM. The
A number (1 to 15 inclusive). Default = 15. This Number must be unique relative to all other Selector ID numbers used in the system.
A number (1 to 16 inclusive). Total number of Call Stations in the system. Default = What the controller senses. Stations are numbered starting with 1 up to this value.
Selector. A number (1 to 15 inclusive). Default = 08.Adjusts the volume of the alert tone (Chime or Beep). A value of 15 is the loudest setting.
Beep or Chime. Default = Chime.
On or Off. Default = Off. Enables the VOX (Voice Activated Transmission) feature
A number (1 to 15 inclusive). Default = 15 (most sensitive).
11