Philips CD491, CD496 user manual Important safety instructions, Power requirements, 60950, English

Page 5
1Important safety instructions

1Important safety instructions

Power requirements

This product requires an electrical supply of 100-240 volts AC. In case of power failure, the communication can be lost.

The voltage on the network is classified as TNV-3 (Telecommunication Network Voltages), as defined in the standard EN

60950.

Power requirements Warning

•• The Electrical network is classified as hazardous.The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible.

To avoid damage or malfunction

60950. Caution

•• Use only the power supply listed in the user instructions.

•• Use only the batteries listed in the user instructions.

•• Risk of explosion if battery is replaced by an incorrect type.

•• Dispose of used batteries according to the instructions.

•• Always use the cables provided with the product.

•• Do not allow the charging contacts or the battery to come into contact with metal objects.

•• Do not let small metal objects come into contact with the product.This can deteriorate audio quality and damage the product.

•• Metallic objects may be retained if placed near or on the handset receiver.

•• Do not use the product in places where there are explosive hazards.

•• Do not open the handset, base station or charger as you could be exposed to high voltages.

•• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.

•• Handsfree activation could suddenly increase the volume in the earpiece to a very high level: make sure the handset is not too close to your ear.

•• This equipment is not designed to make emergency calls when the power fails. An alternative has to be made available to allow emergency calls.

•• Do not allow the product to come into contact with liquids.

•• Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the set.

•• Do not expose the phone to excessive heat caused by heating equipment or direct sunlight.

•• Do not drop your phone or allow objects to fall on your phone.

•• Active mobile phones in the vicinity may cause interference.

When using the phone as a baby monitor

To avoid damage or malfunction Caution

•• Children should be supervised to ensure that they do not play with the appliance.

•• Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/3 feet away).

•• Keep the parent unit at least 1.5 metres/5 feet away from the baby unit to prevent acoustic feedback.

•• Never place the baby unit inside the baby’s bed or playpen.

•• Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket). Always make sure the cooling vents of the baby unit are free.

•• Take every precaution to make sure that your baby can sleep safely .

•• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

•• If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT telephone or wireless router for the internet), the connection with the baby unit may be lost. Move the baby monitor further away from the other wireless appliances until the connection is restored.

•• This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such.

About operating and storage temperatures

Operate in a place where temperature is always between 0°C to +40°C (up to 90% relative humidity).

Store in a place where temperature is always between -20°C and +45°C (up to 95% relative humidity).

Battery life may be shorter in low temperature conditions.

English

EN 3

Image 5
Contents CD491 CD496 User manualPage Contents Technical data ServicesFrequently asked questions Baby monitorPower requirements 1 Important safety instructionsWhen using the phone as a baby monitor Battery life may be shorter in low temperature conditions4 EN What is in the box2 Your phone Overview of the base station Overview of the phoneMain menu icons Display icons Connect the base station and charger 3 Get startedUse only the supplied power adapter to charge the batteries 8 ENConfigure your phone country dependent Install the handsetSet the country/language Set the date and timeCheck the battery level Change the remote access PIN codeCharge the handset Set the date and time formatCheck the signal strength What is standby mode?Make a call 4 CallsQuick call Dial before you callAdjust the earpiece/speaker volumeAnswer a call Mute the microphoneMake a conference call with the external callers Switch between two callsAnswer a second call Make a call to another handset Switch between callsTransfer a call While you are on the phoneDuring the conference call Make a conference callDuring an external call Enter text and numbers Switch between uppercase and lowercase6 Text and numbers 7 Phonebook Access the phonebook during a callView the phonebook Search a recordDelete a record Edit a recordDelete all records Set the personalized melodyCall list type 8 Call logView the call records Save a call record to the phonebookDelete all call records Delete a call recordView the redial records 9 Redial listRedial a call Save a redial record to the phonebookSound settings 10 Phone settingsSet the handsets ringtone volume Set the handsets ringtoneECO mode Set the date and timeSet the key tone Set the docking toneName the handset Display settingsSet the display language Set the backlight of the LCD screenSet the alarm 11 Alarm clockTurn off the alarm Before the alarm ringsAuto conference 12 ServicesCall barring Activate/Deactivate auto conferenceNetwork type Auto prefixSelect the recall duration Dial modeAuto clock First ringRegister the handsets Set the dial modeUnregister the handsets Call servicesManual registration Call forwardCall back service Restore default settingsCall return Hide your identityActivate/Deactivate the baby monitor 13 Baby monitorSend an alert Send to other handsetsSend to a contact from the phonebook Set the baby cry levelSelect a new setting, then press OK to Select a contact from the phonebook, thenTurn the answering machine on or off 14 Telephone answering machineSet the answering machine language Set the answer modeIncoming messages ICM Restore the default announcementRecord an announcement Listen to the announcementDelete an incoming message Listen to the incoming messagesDelete all old incoming messages Call screeningSet the sound quality of the message Remote accessSet the ring delay Select the new setting, then press OK toaccess the answering Behavior of the LED display on the base stationAnswering It keeps scrolling whenPhonebook Phone setup 15 Menu structureRing volume Ring Tone Silent mode Key tone Docking tone My sound Add new View Edit Select melody Delete Delete all Set exceptionAlarm Services Baby monitor Remote access Voice languageActivate Send alert to Baby cry level Connected line External line Mild Moderate Loud16 Technical data Declaration of conformity 17 NoticeUse GAP standard compliance Compliance with EMFEnvironmental information 18 Frequently asked questions Text and number input tables 19 Appendix20 Index 48 EN Philips Consumer Lifestyle EC DECLARATION OF CONFORMITYHK-1151-CD496 YearCD491 HK-1151-CD491Page Page Page All rights reserved UMCD491-49605ENV1.2 WK12092 0168