INSTAllATION
CAUTION: The MC 615 will operate only with nominal 12 volt negative ground battery systems.
It is important to carefully determine the most suitable location for your MC 615 on your vessel. Electrical, mechanical, and environmental considerations must all be taken into
account. You must select the optimum relationship among these considerations.
Keep in mind the flexibility designed into the MC 615 so that you can most conveniently use your radio. Features which should be considered are:
1.Universal mounting bracket may be installed on eithertop or bottom of shelf, bulkhead, or overhead mounting.
2.The microphone connector faces forward allowing convenient
3.The front panel can be fully reversed to provide for optimum viewing and operating for any mounting position.
4.The REMOTE speaker jack may be used with an auxiliary speaker.
All. connections are
ENGINE NOISE SUPPRESSION
Interference from the impulse noise generated by the electrical systems of engines is sometimes a problem with radios. The MC 615 has been designed to be essentially impervious to ignition impulse noise and alternator noise. However, in some installations it may be necessary to take measures to further reduce the effect of noise interference. All DC battery wires, antenna lead, and accessory cables should be routed away from the
engine and engine compartment and from power cabling carrying particularly high currents.
In severe cases of impulse noise interference, it may be necessary to install a noise suppression kit that is available from your Marine Dealer.