Attaching the Touch Screen Protective Sheet
Attach the touch screen protective sheet according to the procedure described below.
Important!
Do not press on the touch screen with excessive force when attaching the touch screen protective sheet. This can damage the touch screen.
1.Switch the power of this unit OFF and remove any dust or other debris from the touch screen.
Front
2. Peel off the film (green) affixed to the front of the protective sheet.
•If you have difficulty in peeling off the film, use a piece of cellophane tape. (After cutting a piece of cellophane tape to a suitable length, hold onto one end of the piece of cellophane tape and press the adhesive side of the other end of the tape onto the green film. The film can be peeled off easily by pulling up the tape.)
•The opposite of the surface where the film was affixed is the surface that is faced to the touch screen.
3.With its front side (the side to which the film was attached) towards you, fix the upper and lower sides of the protective sheet properly to the touch screen. If you encounter difficulties fixing it properly, carefully bend the slight projections at the four corners of the protective sheet to the front.
•Be careful so that dust and other debris is not allowed to get between the touch screen and the protective sheet. Using the Handheld Terminal with dust or other debris trapped between the touch screen and protective sheet can damage the touch screen.
IT600_E_P14_39.p65 | 25 | 05.10.25, 9:50 AM |