Unitech 38647G user manual Getting Started, Installing the Battery

Page 13

Getting Started

Install and charge the battery, check the battery status, turn on the PA600 and cali- brate the PA600’s screen through the following:

Installing the Battery

WARNING! If the Battery Pack is handled improperly there is risk of fire and/or burns. Do not disassemble, crush, puncture, short external contacts, or dispose the battery pack in fire or water. Do not attempt to open or service the battery pack. Dispose of used batteries according to local recycling guidelines.

A Backup Battery cell is embedded in the PA600 to prevent data loss when the remov- able Battery Pack disconnects from the PA600. The Backup Battery will maintain data and system settings for up to 6 hours.

NOTE: Initially charge the Main Battery for at least 16 hours to provide the bat- tery with enough power.

1.Access the Battery Compartment by pushing the Battery Compartment Cover Latch in the direction as shown below:

Components of the Battery Compartment are highlighted below:

Compartment Contacts

Plastic Battery Tab

Battery Hook

NOTE: Do not remove the Plastic Battery Tab, it is useful for removing the Bat- tery.

6

Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.

Image 13

Contents User’s Manual PA600 Rugged Enterprise PDA382647G Version Regulatory Compliance Statements About This ManualFCC Warning Statement FCC Label Statement Laser InformationCanadian Compliance Statement European Conformity StatementBattery charge notice Battery NoticesStorage and safety notice WarrantyTable of Contents System Specification Worldwide Support Advanced SettingsGetting Connected Bar Code Scanner ProgramsIntroducing the PA600 MCA Getting StartedFeatures Package Contents Front View Tour of the PA600Component Description Back View Getting Started Installing the BatteryReplace the Battery Compartment Cover Charging the Battery Using the USB Cable Charging the BatteryChecking the Battery Status Charging the Battery with the Docking StationLED Status MeaningConnecting the PA600 to a PC Turning PA600 on for the First Time Powering OnUsing the Stylus Calibrating the PA600 Screen Tap Start → Settings → Control PanelPage Set Date and Time Setting the Data and TimeKeypads and Function Buttons Using the HardwareKey Main Function Secondary Function Using the Hardware Using the SD/MMC memory card Adjusting the Screen BrightnessInserting a Storage Card Removing a Storage Card Using the Laser ScannerTap Tools → Enable Scan → Settings → Control Panel → double- tap ScannerScan2Key Icon Tap Start → Programs → Rfidhf → Rfidhf Using the Rfid HF ReaderUsing the Hardware Getting Connected Installing Microsoft ActiveSyncEstablishing Device-PC Connection Getting Connected Page Connecting the Device to the Computer Page Connection Options Synchronizing with the ComputerUSB Connection Tap Start → Programs → Communication Check Enable direct connections to the desktop computerBluetooth Connection Page Getting Connected BTAciveSync Icon Wi-Fi Connection Page Synchronization Options Synchronizing InformationUse Microsoft ActiveSync to Exchange Files Page Bar Code Scanner Programs Scanner SettingScan2Key Bar Code Symbologies 2D Bar Code Bar Code Symbologies 1D Bar CodeAdjusting Settings Advanced SettingsTap Start → Settings → Control Panel → double-tapPower Checking Main and Backup Battery StatusChanging the Automatic Power Settings Extending Battery LifeAdjusting Backlight Setting Viewing Flash Memory Files Performing a Warm Boot Performing a hardware resetPerforming a Cold Boot Appendix System SpecificationRegion Web site Worldwide Support