Basic settings
Basic settings
1.After installing the batteries, the display should flash the word
ENGLISH.
If not press and hold 
for approximately 4 seconds.
2.Select the desired language using 
or 
. Press DELETE/OK button.
3.Select the desired contrast setting (2=Default) using 
or 
. Press DELETE/OK button.
4.Set the month using 
or 
. Press DELETE/OK button.
5.Set the day using 
or 
. Press DELETE/OK button.
6.Set the hour 
or 
. Press DELETE/OK button.
7.Set the minute using 
or 
. Press DELETE/OK button.
Display(LCD)Contrast/Time Setting
If you wish to change the language, contrast, time settings at a later date, press and hold 
button for approximately 4 seconds and repeat steps
Select country version
1.For New Zealand Select Recall = 600 on the switch on the rear side of the unit, New Zealand Recall/flash time is 600ms, the unit is now set up to insert 0/00 when receiving CID log in accordance with Telecom
NZ requirements. Or for Australia Select Recall = 100.
2.Lift and replace the handset to initialize.
NOTE:
If the switch is in the incorrect position Caller ID and the recall function will not operate correctly.
8