Installation, If you have a Broadband line

Installation

Installing batteries (supplied) in the phone

Warnings

Before opening the battery compartment, make sure the telephone is disconnected from the telephone line.

You must install 4 AAA Alkaline batteries (supplied) in the phone base to retain memory and CID information when the telephone is disconnected from the line.

1.Use a flat-blade screwdriver or tip of a pen to lift and remove the battery compartment door.

2.Insert four AAA batteries into the compartment as indicated by the polarity symbols.

3.Snap the battery compartment door back into place.

When this symbol appears on the display or the display dims, replace

the batteries. Always use 4 new high quality Alkaline AAA batteries.

If you have a Broadband line

If you connect your telephone to a line with a broadband connection, you must connect an in line filter (not supplied) between the telephone socket and your phone base to ensure that your broadband and TP30 will work properly.

If you do not install the filter you will experience interference on the cordless phone and your Broadband may suffer dropouts. Please refer to the user guide of the in line filter for installation.

In a home with broadband, every telephone, fax or answering system must have a in-line filter connected, not just the one at the telephone point that your modem is connected to.

Additional in-line filters can purchase from electronic stores.

Connecting the telephone

1.Plug one end of the curly cord into the socket on the handset.

2.Plug the other end of the curly cord into the left side of the phone.

3.Plug one end of the telephone line cord into the jack at the back of the base, and the orher end into the wall socket.

4.Pick up the handset and listen for dial tone.