Uniden 1380BK manual Telephone Operation, Reviewing the Announcement, Using the Speakerphone

Page 12

•To return to the answerer’s default greeting after you’ve recorded one, press ANNOUNCE and release it when you hear the tone, or press and hold DELETE when the greeting is playing.

Reviewing the Announcement

Press and release the ANNOUNCE button to review your outgoing announcement.

Telephone Operation

Using the Speakerphone

Speakerphone Location

For best speakerphone performance, avoid the following:

•Areas with high background noise. (The microphone might pick up these sounds and prevent the speakerphone from going into the receiving mode when you finish talking.)

•Surfaces affected by vibration.

•Recessed areas such as in a corner, under a cupboard, or next to a cabinet, which can generate an echo effect.

Speakerphone Use

Note the following guidelines when using the speakerphone:

•The speakerphone works similar to a two-way radio in that you can only listen or talk at one time.

•Stay reasonably close to the phone so that you can be clearly heard by the person to whom you are talking.

•You can adjust the speaker volume by pressing the VOL (+ or -)buttons.

•The speakerphone indicator comes on when the speakerphone is in use.

12

Image 12

Contents

User’s Guide Important Information Interference InformationTelephone Network Information REN Number Hearing Aid CompatibilityLicensing FCC RF Radiation Exposure StatementTable of Contents Message Indicators Parts Checklist Introduction Before You BeginTelephone Jack Requirements Important Installation Information Switch Base LayoutInstalling the Phone Desktop InstallationWall Mounting the Phone Instructions for Moving Rotate the stand 180 degrees, and insertAnswering System Setup AnswererRecording the Outgoing Announcement Using the Speakerphone Telephone OperationReviewing the Announcement Speakerphone LocationSwitching between Speaker and Handset Receiving a Phone CallPlacing a Phone Call Temporary Tone DialingFlash RedialMute Telephone Set Up Setting the Rings to AnswerSetting the Incoming Message or Memo Length Setting the Recording QualityToll Saver Setting the Security Code Setting the Display ContrastSetting Your Local Area Code Setting the Dialing ModeSetting Day of Week Setting the Time and Date HourMinutes MonthSetting the Language Message VolumeRinger Volume DateHandset Volume Speakerphone VolumeCaller ID Features Summary ScreenCaller ID with Call Waiting Receiving and Storing CallsReviewing Call Records Deleting CID Records Dialing BackIf You Programmed Your Local Area Code If You Did Not Program Your Local Area Code Memory Storing a Number in MemoryStoring a Redial Number to Memory Erasing a Stored Number Copying Caller ID Memories to User MemoryInserting a Pause in the Dialing Sequence Changing a Stored NumberDialing a Number Stored in Memory While On- hook Dialing a Number Stored in MemoryReviewing Stored Numbers Chain Dialing from Memory Number For Memory LocationAnswering System Operation Call AnsweringAuto Disconnect Playing Messages Erase MessagesRemote Access Leaving a MemoMemory Full Remote Access Commands Message Indicators Unknown NumberTroubleshooting Guide Telephone SolutionsPage General Product Care Causes of Poor Reception Warranty Index Inserting a Pause in the DialingPlacing a Phone Call If You Contact Uniden’s Phone Number