Panasonic KX-TCD410AL operating instructions Battery Charge, Battery Life

Page 7

Setting up

Battery Charge

At the time of shipment, the batteries are not charged. To charge, place the handset on the base unit. Please charge the batteries for about 7 hours before initial use. During charging, the battery icon is as shown below.

Fully charged	During charging
(Flashing)
Display icon	Battery strength
	High
	Medium
	Low
	Needs to be
	charged

The handset which power is off will be turned on automatically when it is placed on the base unit.

In normal use, the handset and the base unit should be powered on at all times.

Battery Life

Battery life is dependent on use and conditions but in general when using fully charged Ni-MH batteries (700 mAh): Talk time: 10hrs approx.

Standby time: 120hrs approx.

When using Ni-Cd batteries (250 mAh): Talk time: 4hrs approx.

Standby time: 40hrs approx. (Times indicated are for peak performance.)

The batteries reach peak performance after several full charge/discharge cycles. The batteries cannot be overcharged unless they are repeatedly removed and replaced.

If battery life is shortened then please check that battery and charge terminals are clean.

For maximum battery life, it is recommended that the handset not be

recharged until battery icon flashes .

Preparation

7

Image 7

Contents Model No. KX-TCD410AL ContentsBefore Initial Use Accessories includedImportant Information InstallationInstructions to customer Service difficulties Environment Battery CautionLocation Battery Installation Setting upConnection Battery Life Battery ChargeSelecting the Battery Type Symbols Used in This Operating InstructionsReplacing the Batteries Base unit Location of ControlsHandset Display HandsetWall Mounting Making a Call Using the TelephonePower On/Off Setting the Clock/DateRedialling Making CallsClearing One/All Dialled Items in the Redial List Using Caller ID Type Caller ID ServiceCaller ID Caller ID Calling Back Caller ID ListEditing the Received Number in the Caller List Temporary Bell Off Receiver VolumeAnswering Calls Auto TalkStoring a Caller Information PhonebookDialling with the Phonebook Editing a Caller InformationNumber Clearing a Caller InformationPhone Number *1 Name Clearing the Hot Key Registration Hot KeyRegistering a Phone Number as a Hot Key Dialling with Hot KeyBefore programming, please follow steps 1 to Handset SettingsTime Alarm Setting Time Alarm On/OffRinger Option Setting the Ringer VolumeTone Option Selecting the Standby Mode DisplayDisplay Option Digit Selecting the Talk Mode DisplayCall Option Call BAR On/OffSetting the Direct Call On/Off Setting the Direct Call NumberOther Options Dialling Pause for PBX line/long distance service users Recall FeatureKey Lock Digit Base Handset Number Unit PIN*1 Base Unit SettingsPause Timing Cancelling Call Restricted Number 4 4-digit Base Unit PIN*1Selecting the Recall Time 4 Base Unit 5 2 6 1 PIN *1Reset Handset Settings Initial SettingsHandset Initial Settings Function Base Unit Initial Settings Function Reset Base Unit SettingsDigit Base Unit PIN*1 Multi-unit User Operation Cancelling a Handset Cancelling a Base UnitDigit Handset PIN *1 Number of Rings *3 Ringer Mode Selection Setting the All Handsets ModeSetting the Selected Handsets Mode Handset Numbers *2 Setting the Selected then All Handsets ModeBase Unit Selection Intercom between Handsets IntercomTransferring a Call to Another Handset/Conference Call Before Requesting Help Problem Possible cause SolutionBefore Requesting Help Technical Information SpecificationsConnections PIN IndexPQQX13520ZA F0803-1093 For your future reference