Recording operations
16
Side A
Tab for side “B” Tab for side “A”
To
Normal tape |
Detection hole
Present state (e.g., elapsed play time of CD)
Present time
Tape counter
Before recording
Use household AC power or new batteries when recording to avoid poor recordings caused by the batteries running down.
Televisions can cause interference to recordings made on this unit if the two are too close to each other.
Selection of tapes for recording
The unit automatically identifies the type of tape.
Normal position/TYPE | O.K. |
High position/TYPE | O.K. |
Metal position/TYPE | NO |
Metal position tapes can be used, but the unit will not be able to record or erase them correctly.
Volume and sound quality in recording
•Recording level is set automatically.
•Recordings are unaffected by changes to sound quality.
Selecting reverse mode
Remote control only
Press [REV MODE].
and 
: Both sides record (top side 
bottom side).
: One side only records.
Erasing recordings
Insert the cassette with the side to be erased facing up.
Press [ 
TAPE/CD] to switch to TAPE mode.
Press [ 
].
Erasure prevention
The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown, be- ing careful not to cover the high position discrimination hole.
To display the tape counter while recording
Remote control only
Press [DISPLAY].
Each time the button is pressed in CD, Radio, or AUX mode
To reset the tape counter
Press
The counter resets to “000”.
Your attention is drawn to the fact that recording pre- recorded tapes or discs or other published or broadcast material may infringe copyright laws.
RQT5142