Panasonic RX-ED50 manual Automatic CD recording, To continue recording from another CD

Page 18

Recording operations

�

18

RQT5142

Automatic CD recording

You can record the whole CD (AUTO) or a selected track(1- REC). If a track is interrupted at the end of the side facing up, it is recorded again on the side facing down.

AUTO

Recording begins from the side facing up and the reverse

mode is set to “ ”.

Preparation: Insert a CD ( page 9)

Press [ TAPE/CD] to switch to CD mode.

Press [CD REC MODE] so “ AUTO” is dis- played.

Each time the button is pressed

AUTO 1-REC OFF

The display shows the length of tape needed.

“C-- -- -- --” indicates the tape needed exceeds 100 minutes. You can still record, but some tracks may not be recorded if the tape isn’t long enough.

Press [ DECK 2] to open the deck and load a cassette.

Close deck by hand.

Press [ ] to start recording.

The unit rewinds the tape, records 10 seconds of si- lence, and then starts recording.

To stop recording

Press [ TAPE/CD]. The CD also stops.

To record selected tracks

Program tracks ( steps and on page 11).

Do steps to .

You cannot use AUTO with repeat or random play ( page 10).

1-REC

Preparation:

Insert a CD ( page 9) and a cassette.

Wind the tape to where you want to start recording.

Press [ TAPE/CD] to switch to CD mode.

Press [CD REC MODE] so “ 1-REC ” is dis- played.

Turn [ TIME/PRE.TUNE/CD] to select the track you want to record.

Press [ ] to start recording.

CD play and recording start at the same time.

To stop recording

Press [ TAPE/CD]. The CD also stops.

To continue recording from another CD

Press [ CD OPEN/CLOSE] and insert the other CD. Do steps and .

To record a track while it is being played

Press [CD REC MODE] so “1-REC ” is displayed.

Press [ ].

Recording starts from the beginning of the track and stops when the track finishes.

Image 18

Contents RX-ED50 Table of contents Class Laser ProductEB area code model only UseSupplied accessories PrecautionsUsing batteries not included Power sourcesOperating the unit on AC power Memory back-up batteriesBefore Location of controlsBasic controls Tuner/CD controlsUse Remote controlButtons Do notWhen batteries are used Setting the timePress to turn the unit on Press CLOCK/TIMER to select Clock Press DisplayCDs Press TAPE/CD to switch to CD modePress -,+ Volume to adjust the volume DiscCompact disc operations CDsOther modes of play Program play To check the contents of the programPress Full is displayedRadio manual tuning OperationsSelecting channels Radio preset tuningPresetting radio stations RadioCassette deck operations Press TAPE/CD to switch to Tape modeCassettes Press Deck 1 to open the deck and load a cassettePress REW-TUNE/ backward Or TUNE/ -FF forward Press REV ModeCassettes Press Deck 1/2Erasing recordings Before recordingRecording operations Erasure preventionRecording CDs Deck 2 only Press Deck 2 to open the deck and load a cassettePress to start recording Automatic CD recording To continue recording from another CDTo record a track while it is being played Recording the radio Recording tape-to-tapePress CLOCK/TIMER to select the timer function Using the timerTimer operations Press PLAY/RECSleep timer Using the timerPress Sleep to select the time in minutes Timer fader Creating a three dimensional sound field with S.VirtualizerSound quality Press to switch to AUX mode Start playback on the equipment Using auxiliary equipmentMaintenance Using headphones not includedTroubleshooting Technical specifications