Panasonic KX-TG7200HK Operating additional units, Registering a handset to the base unit

Multi-unit Operation

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the base unit.

Important:

L The additional handset model recommended for use with this unit is noted on page 4. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.

L Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call.

Registering a handset to the base unit

The supplied handset and base unit are pre-registered. When you purchase an additional handset, refer to the additional handset’s installation manual for registration. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), register the handset.

1{j/OK}

2{^}/{V}: “Handset Setup” i

{>}

3{^}/{V}: “Registration” i{>}

4{^}/{V}: “Register H.set” i

{>}

5Press and hold {x} on the base unit for about 5 seconds. (No registration tone)

L If all registered handsets start ringing, press {x} to stop, then repeat this step.

L After pressing {x}, the rest of this procedure must be completed within 90 seconds.

6Wait until “Enter Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). i{j/OK} L If you forget your PIN, consult

your nearest Panasonic service centre.

L When the handset has been registered successfully, w will stop flashing. If the key tone is turned on (page 17), a confirmation tone will be heard.

Deregistering a handset

A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.

1{j/OK}

2{^}/{V}: “Base Unit Setup” i

{>}

3Enter “335”.

4{^}/{V}: “Deregistration” i

{>}

L The numbers of all handsets registered to the base unit are displayed.

5Select the handset(s) you want to cancel, by pressing the desired handset number. i{j/OK}

L The selected handset number(s) will flash.

21