Press (FLASH) if you hear a call-waiting tone while talking.
≥The first call is put on hold and you can answer the
second call.
≥To return to the first caller, press (FLASH) again.
5-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press ($) (TONE) before entering access numbers which require tone dialing.
≥The dialing mode changes to tone. You can enter numbers to access answering services, electronic banking services, etc. When you hang up, the mode will return to pulse.
≥Access numbers entered after pressing ($) (TONE) will not be included when redialing.
(For PBX Line/Long Distance Calls)
We recommend you press (PAUSE) if a pause is required to dial with a PBX or to make a long distance call.
Ex. Line access number (9) (PBX)
(9)¤ (PAUSE) ¤ Phone number
≥Pressing (PAUSE) once creates a few seconds pause. This prevents misdialing when you redial or
dial a stored number.
≥Pressing (PAUSE) more than once increases the length of the pause between numbers.
The unit can be mounted on a wall.
1Press the tabs in the direction of the arrows
(1), then remove the wall mounting adaptor (2).
11
2Tuck the telephone line cord inside the wall mounting adaptor, and push it in the direction of the arrow (1 and 2).
≥The word “UP WALL” should face upward.
3Connect the telephone line cord. Mount the unit, then slide down.
≥Fasten the cord to prevent it from being disconnected.
2
Wall Phone
Plate
2 
1
To temporarily set the handset down during a conversation, place it as shown here.
Problem | Remedy |
The unit does | ≥Check the settings |
not work. | (1-B). |
The call cannot | ≥Check whether the |
be connected | DIALING MODE selector |
even if you | setting is correct or not |
dialed correctly. | (1-B). |
The unit does | ≥The RINGER selector is |
not ring. | set to OFF. Set to HIGH |
| or LOW (1-B). |
You cannot | ≥Confirm the handset is off |
store a phone | the cradle. |
number in | ≥Do not enter a phone |
memory. | number more than 21 |
| digits long, or the entered |
| number and the |
| previously stored number |
| will be cleared. |
| |
ProblemRemedy
The other party ≥(PROGRAM) was pressed
suddenly cannot during the conversation.
hear your voice Press (PROGRAM) again. during a
conversation.
You cannot | ≥If the last number dialed |
redial by | was more than 31 digits |
pressing | long, the number will not |
(REDIAL). | be redialed. |
| |
If you cannot | ≥Call our customer call |
solve your | center at |
problem | 1-800-211-PANA(7262). |
| ≥Panasonic’s e-mail |
| address for customer |
| inquiries: |
| consumerproducts@panasonic.com |
| for customers in the USA |
| or Puerto Rico ONLY |
6-C Specifications
Power Source:From telephone line
Dimensions (H x W x D):
Approx. 96 mm x 150 mm x 200 mm
| (3 25⁄32q k 5 29⁄32q k 7 7⁄8q) |
Mass (Weight): | Approx. 495g (1.09 lb.) |
Dialing Mode: | Tone (DTMF)/Pulse |
Operating Environment: | 5°C–40°C (41oF–104oF) |
Specifications are subject to change without notice.
6-D Helpful Information
≥Environment—do not place the unit in a room where the temperature is less than 5°C (41oF) or greater than 40°C (104oF). Allow 10 cm (4q) clearance around the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight.
≥Routine care—wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder.
≥If there is any trouble—disconnect the unit from the telephone line and connect a known working phone. If the known working phone operates properly, have your unit repaired by one of the authorized Panasonic Factory Service Centers. If the known working phone does not operate properly, consult your telephone company.
For product service
≥Call 1-800-211-PANA(7262) or 1-800-833-9626 for the location of an authorized servicenter.
≥Panasonic’s e-mail address for customer inquiries: consumerproducts@panasonic.com
for customers in the USA or Puerto Rico ONLY
When you ship the product
≥Carefully pack your unit, preferably in the original carton.
≥Attach a letter, detailing the symptom, to the outside of the carton.
Symptom
≥Send the unit to an authorized servicenter, prepaid and adequately insured.
≥Do not send your unit to the Panasonic Consumer Electronics Company listed on the back cover or to executive or regional sales offices.
These locations do not repair consumer products.
7-A Pasos Iniciales
1 Conecte el cable de la línea telefónica (1). | 3 |
2Conecte el cordón del auricular (2), luego confirme el tono para marcar.
A toma de teléfono de una sola línea (RJ11C)
Cable de la línea telefónica
1
4
Selector del
DIALING MODE
Selector del
RINGER
2
Auricular
Cordón del auricular
Coloque el selector del DIALING MODE a TONE (tono).
≥Si Ud. no puede marcar colóquelo en PULSE (pulso).
DIALING MODE
TONE 
PULSE
Coloque el selector del RINGER a HIGH (alto), LOW (bajo) u OFF (apagado). (Ej. se selecciona “HIGH”.)
RINGER
HIGH 
OFF
≥Cuando esté colocado en OFF, la unidad no sonará.
7-B Haciendo Llamadas
1Levante el auricular.
2Marque el número de teléfono.
≥Si Ud. se equivoca al marcar, cuelgue y comience de nuevo desde el paso 1.
3Cuando termine de hablar, cuelgue.
Para remarcar el último número marcado
Levante el auricular. ¤ Presione (REDIAL).
≥(REDIAL) marcará el último número que se introdujo manualmente, no llamará a un número de marcación rápida (3-B) ni a un número de marcación de un solo toque (4-B).
Para ajustar el volumen del auricular (6 niveles) mientras habla
Para aumentar, presione (^).
Para disminuir, presione (_).
≥Cada vez que Ud. presione el botón, el nivel del volumen cambiará.
≥Después de colgar, el nivel del volumen se guardará.
7-C Contestando Llamadas
1Cuando la unidad suene, levante el auricular.
2Cuando termine de hablar, cuelgue.
