TG1311_1312_1313BX(e).book Page 18 Tuesday, September 2, 2008 10:36 AM
Useful Information
Transferring calls, conference calls
Available for:
Outside calls can be transferred between 2 handsets. 2 handsets can have a conference call with an outside party.
Example: When handset 1 transfers a call to handset 2
1Handset 1:
During an outside call, press {INT}. iPress {2} (desired handset number).
L The outside call is put on hold.
L If there is no answer, press {INT} to return to the outside call.
2Handset 2:
Press {C} to answer the page.
L Handset 2 can talk with handset 1.
3Handset 1:
To complete the call transfer, press {ih}. To establish a conference call, press {3}.
Transferring a call without speaking to the other handset user
1During an outside call, press {INT}. iEnter the desired handset number.
L kflashes to indicate the outside call is on hold.
2{ih}
L The outside call rings at the other handset.
Note:
LIf the other handset user does not answer the call within 30 seconds, the call rings at your handset again.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.
Problem | Cause/solution |
w is flashing. | L The handset is too far from the base |
| unit. Move closer. |
| L The base unit’s AC adaptor is not |
| connected. Check the connections |
| (page 4). |
| L You are using the handset or base unit |
| in an area with high electrical |
| interference. |
| and use the handset away from |
| sources of interference. |
| L The handset registration is cancelled. |
| Register the handset to the base unit |
| (page 20). |
18