Panasonic KX-NT265 manual Important Notice, Trademark

Page 2

Important Information

WARNING:

TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

THIS HANDSET EARPIECE IS MAGNETISED AND MAY RETAIN SMALL FERROUS OBJECTS.

UNPLUG THIS UNIT FROM POWER OUTLET/THE ETHERNET CABLE IF IT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES UNUSUAL NOISE.

THESE CONDITIONS CAN CAUSE FIRE OR ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND CONTACT AN AUTHORISED SERVICE CENTRE.

IMPORTANT NOTICE:

Under power failure conditions, the IP-PT may not operate. Please ensure that a separate telephone, not dependent on local power, is available for use in remote sites in case of emergency.

For information regarding network setup of the IP-PT such as IP address, please refer to the Installation Manual for the Panasonic Hybrid IP-PBX.

If an error message is shown on your display, consult the network administrator.

The firmware of the KX-NT265 is protected by copyright laws and international treaty provisions, and all other applicable laws. It can not be reverse engineered, decompiled or disassembled.

This unit is capable of being used in conjunction with hearing aids fitted with inductive coil pick-ups. The handset should be held as for normal conversation. For operation, the hearing aid should be set to its “T” position or as directed in the operating instructions for the hearing aid.

Note:

In this manual, the suffix of each model number is omitted.

Trademark:

Ethernet is either a registered trademark or a trademark of Xerox Corporation in the United States and/or other countries.

This model supports the following PBX and IP-EXT card versions: KX-TDA100/KX-TDA200: PMPR Software File Version 3.0000 or later KX-TDA600: PLMPR Software File Version 3.0000 or later KX-TDA0470(IP-EXT16): PIPEXT Software Version 1.001 or later/ PVOIPEX Software Version 1.011 or later

2

Image 2
Contents Important Information Installation EnvironmentPlacement Important Notice TrademarkDuring a Conversation Features ListMaking Calls Useful Features Before Leaving Your Desk Setting the Telephone According to Your Needs Location of Controls Also used as feature buttons. Button assignment is requiredMessage/Ringer Lamp When you LCD Liquid Crystal DisplaySettings on the Programming Mode To enter the programme mode To exitEthernet cable Straight CAT 5 or higher cable not included Tilt AngleConnection Mount the unit on the wall Wall MountingAC adaptor Order No 83 mmTo AC Outlet To a Switching Hub LANInstall 2 screws spaced 83 mm or Mm apart, to the wallCopyright InformationFor business users in the European Union