Patton electronic 07MSDTA-QS quick start Power up the Smart-DTA, Qualified service personnel

	• The Smart-DTA contains no user serviceable parts. The equipment
	shall be returned to Patton Electronics for repairs, or repaired by
WARNING	qualified service personnel.
	• Mains Voltage: Do not open the case the power cord is attached. The
	external power adaptor shall be a listed limited power source that
	incorporates a disconnect device and shall be positioned within easy
	reach of the operator. The mains outlet shall be within 10 feet (3
	meters) of the device, shall be easily accessible, and protected by a
	circuit breaker.
	• The Smart-DTA is not shipped with power cables. For AC powered
	units, ensure that the power cable used meets all applicable stan-
	dards for the country in which it is to be installed, and that it is con-
	nected to a wall outlet which has earth ground.
	• Hazardous network voltages are present in WAN ports regardless of
	whether power to the Smart-DTA is ON or OFF. To avoid electric
	shock, use caution when near WAN ports. when detaching the cables,
	detach the end away from the Smart-DTA first.
	• Do not work on the system or connect or disconnect cables during
	periods of lightning activity.

1.0 Power up the Smart-DTA

The terminal block header to which the wires are secured provides the disconnect for the Smart-DTA. Take proper measures to ensure that it is not permanently fastened to the receptacle mounted on the chassis.

CAUTION

1.Connect the Smart-DTA to a power source using the included power supply and cable.

2.When the Power LED stops blinking and remains lit, the Smart-DTA is ready to configure.

2 Smart-DTA Quick Start Guide