Tyan Computer B5103G12S2, Transport GS12 manual Replacing the Power Supply

Reverse the above sequence when installing the new LCD module.

8.7 Replacing the Power Supply

To replace the system’s power supply, follow these procedures.

1.Remove the cabinet cover (see the previous section in this chapter).

2.Remove the secondary hard disk drive (see chapter 7 on Adding a Secondary Hard Disk Drive).

3.Detach the 4-pin 12 V plug from the ATX 12 V connector on the motherboard as well as the 20-pin connector from the ATX connector on the motherboard. Then, remove the two screws.

4. Remove the two screws securing the power supply to the system’s rear panel.

81

http://www.TYAN.com