Secondary IDE Connector
3. Secure the hard disk drive to the bracket with four bottom screws.
4.Fit the bracket with the hard disk drive back into place and secure with one screw.
5.If using an Ultra ATA/100 hard disk drive, connect one end of the included secondary IDE data cable to the secondary IDE connector (see figure above) and the other end to the rear of the hard disk drive. Then connect the power cord.
If using a Serial ATA hard disk drive, connect one end of the included Serial ATA data cable to the secondary Serial ATA connector and the other end to the rear of the hard disk drive (Œ). Connect the corresponding end of the included Serial ATA power cord to the end of the existing power cord (•) and the other end to the hard disk drive (Ž).
74
http://www.TYAN.com
