3.Untar/unzip archive: tar xfvz asfm-x.x.tar.gz.
4.Change to the driver directory: cd
5.Install the WatchDog driver: make make install.
3.3Installation Instructions for FreeBSD 4.7
NOTE: Do not allow USB devices to be hot plugged during installation of the Linux operating system.
FreeBSD 4.7 Installation Notes
NOTE: As of the writing of this User’s Manual, your system only supports the FreeBSD 4.7 operating system. This is because FreeBSD 5.1/5.0’s hardware support list does not include the ICH5 or Intel 875 chipsets.
Perform the following first before proceeding with FreeBSD 4.7 operating system installation:
1.Upon booting the system, press F2 to enter BIOS Setup. Load Setup defaults and set the CD drive as the primary boot device, then save and exit the BIOS Setup.
2.Connect the USB keyboard and mouse to your system’s rear USB ports.
3.Insert the FreeBSD 4.7 Installer disc 1 to the CD drive and press Enter quickly, or press any key for the command prompt.
4.On the Kernel Configuration Menu, select Start kernel configuration in CLI mode.
5.On the config prompt, type disable atkbd0, then press Enter.
6.Type quit, then press Enter.
7.Install the FreeBSD 4.7 operating system, and then proceed to the following driver installation.
FreeBSD 4.7’s default kernel has no apm function. In order to allow a complete system shutdown, please update the kernel by performing the following steps:
cd /usr/src/sys/i386/conf mkdir /root/kernels
cp GENERIC /root/kernels/MYKERNEL ln -s /root/kernels/MYKERNEL
vi MYKERNEL
Locate the line: devices apm0 at *********, change it to devices apm0.
36
http://www.TYAN.com
