Wall Mount Installation
Note: see below if cabinet installation is preferred
3.After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 7- 1/2”. See also Figure 4a.
4.Find the centerline of the cooktop. Draw a vertical line along this centerline up to the hori- zontal line drawn in step 1 and draw a vertical line right and left at a distance
5.Fit two mounting hooks on the wall to hang the hood through the provided slots (2 wall anchors + 2 hooks + 2 screws 5x35).
6.Run 10” Duct, long enough to reach the transition once the hood has been installed plus 1 1/2” inch to connect ductwork. Fix Duct to transition with screws and seal withtape.
7.Remove 1 of 2 knockouts and install 1/2” conduit connector in
8.Hang the hood and adjust its position through the screws on the hooks.
9.Fix the hood to 4 additional point, 2 on upperside, 2 on lower side (use 4 wall anchors
+4washers + 4 screws 5x35.
Cabinet Installation:
Note: See above if wall mount installation is preferred
Note: Distances on Table 3.3.
Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of the cabinet. See also Figure 4b.
4.Draw two lines, one at a K distance from thewall, the other one at a Z distance from theprevious line. Mark 4 points, two along each line at a distance of half W from the center line, to determine the screw locations.
5.Fit 4 screws on cabinet bottom do not tighten completely but leave a space of about 1/2” from cabinet bottom surface and head screws.
6.Run 10” Duct, long enough to reach the transition once the hood has been installed plus1 1/2” inch for connect ductwork.
7.Remove 1 of 2 knockouts and install 1/2”conduit connector in
8.Hang the hood on screws through side slots provided on hood top.Tighten the four screws. Note: If possible fix the hood on the wall at 4 additional point (2 on upper side, 2 on lowerside).
9.From the inside of the cabinet attach the transition on upper outlet.
HOO D W IDTH | DIM. "W " | DIM. "K " | DIM. "Z" | ||
30" | 29 - 1/8" | 2 | - 1/2" | 7 | - 1/16" |
36" | 35 - 1/16" | 2 | - 1/2" | 7 | - 1/16" |
Table 3
Figure 4a | Side slot x 4 |
| Center Hole |
Figure 4b
9
