Uniden UH-048XR manual Ctcss Tone Display

Page 15

On the example below only radio 1 and 9 can communicate or hear each other because they are using the same or common CTCSS code.

1

CH1 Code 1

CODE 1

CH1

Code 1

9

2

CH1 Code 7

CODE	7

3

CH1

No CTCSS Code

CTCSS Tone Display

This feature allows you to select the preferred display format for the CTCSS code setting. If frequency was chosen, then the display in the CTCSS will be

shown as frequency. However, if the number was chosen, then the code number will be displayed in CTCSS function.

1. Press [Function] button

until appears in the large display.

2.Press [▲] or [▼] to change the format.

12

Image 15

Contents Operating Guide Page Contents Introduction FeaturesTechnical Support and Service UH-048XR Wrist Strap Belt ClipOperating Guide Battery Installation Slide the battery cover forward until it snaps into placeGetting Started Corner LOW Battery AlertIndicates a fully powered unit. As the batteries lose Power Belt ClipWrist Strap Press and hold Power ON/OFFVolume OperationTo Transmit and Receive Press toWill be displayed Transmission TX indicatorsTX indicators will then disappear on the LCD Display shows Transmission is being received by your radioScanning Monitor. PressFlashes Press or to Select up or down Programming Ctcss Code Continuous Tone Coded Squelch System CtcssCtcss Tone Display To set the timing Press Function button until appears VOX Recovery TimeVoice Activated VOX Press to confirm yourAuto Keylock Call Melody Radio momentarily beeps as appears onTo deactivate keylock temporarily, press and hold To use monitor MonitorLevel Battery Level DisplayBattery Charge UHF Channels & Frequencies Speaker Microphone SM-048 Headset Microphone HM-048 AccessoriesOptional Accessories AC Adaptor AAD-048 Desk Top Charger DTC-048Transmitter GeneralReceiver Uniden UH-048XR UHF CB Radio WarrantyProcedure for obtaining performance or warranty Controls & Indicators External Mic/Speaker Page Page Uniden Australia Pty Limited/ Uniden New Zealand Limited