Uniden UH-048XR manual Getting Started, Battery Installation

Page 7

GETTING STARTED

BATTERY INSTALLATION

Your UH048XR radio uses 4 AAA batteries (not supplied) for power.

Please refer to page 14 should you wish to use rechargeable batteries.

Do not mix old and new batteries for optimum performance.

To install the batteries:

1.Make sure your radio is off.

2.Press battery cover release. Slide cover off.

3. Insert 4 AAA batteries (not supplied) according to the polarity symbols

inside the battery compartment.

4.Slide the battery cover forward until it snaps into place.

4

Image 7
Contents Operating Guide Page Contents Introduction FeaturesTechnical Support and Service Wrist Strap Belt Clip UH-048XROperating Guide Slide the battery cover forward until it snaps into place Battery InstallationGetting Started Corner LOW Battery AlertIndicates a fully powered unit. As the batteries lose Power Belt ClipWrist Strap Press and hold Power ON/OFFVolume OperationPress to To Transmit and ReceiveWill be displayed Transmission TX indicatorsTX indicators will then disappear on the LCD Display shows Transmission is being received by your radioMonitor. Press ScanningFlashes Press or to Select up or down Programming Ctcss Code Continuous Tone Coded Squelch System CtcssCtcss Tone Display To set the timing Press Function button until appears VOX Recovery TimeVoice Activated VOX Press to confirm yourAuto Keylock Radio momentarily beeps as appears on Call MelodyTo deactivate keylock temporarily, press and hold To use monitor MonitorLevel Battery Level DisplayBattery Charge UHF Channels & Frequencies Speaker Microphone SM-048 Headset Microphone HM-048 AccessoriesOptional Accessories AC Adaptor AAD-048 Desk Top Charger DTC-048Transmitter GeneralReceiver Uniden UH-048XR UHF CB Radio WarrantyProcedure for obtaining performance or warranty Controls & Indicators External Mic/Speaker Page Page Uniden Australia Pty Limited/ Uniden New Zealand Limited