Uniden UH-048XR manual Battery Charge

Page 21

BATTERY CHARGE

Warning Notice! This UH048XR is designed to charge Ni-Cd batteries only.

Use only the power Adaptor AAD-048S with 4 AAA size Ni-Cd batteries.

Turn the power off. Follow charging set-up below.

Function

Monitor

Power/Enter

UH048

OR

Note 1: To fully charge the battery, leave the AC Adaptor (AAD- 048S) charging for 14-16 hours.

Note 2: Disconnect the AC Adaptor from the unit when charging is completed.

Note 3: When using the Desk Top Charger, the UH048XR must be placed with its front view facing the short part of the charger.

Charging batteries other than

NiCd may damage the radio.

18

Image 21

Contents Operating Guide Page Contents Introduction FeaturesTechnical Support and Service UH-048XR Wrist Strap Belt ClipOperating Guide Battery Installation Slide the battery cover forward until it snaps into placeGetting Started Indicates a fully powered unit. As the batteries lose Power LOW Battery AlertBelt Clip CornerWrist Strap Volume Power ON/OFFOperation Press and holdTo Transmit and Receive Press toWill be displayed TX indicators will then disappear on the LCD Display shows TX indicatorsTransmission is being received by your radio TransmissionScanning Monitor. PressFlashes Press or to Select up or down Programming Ctcss Code Continuous Tone Coded Squelch System CtcssCtcss Tone Display Voice Activated VOX VOX Recovery TimePress to confirm your To set the timing Press Function button until appearsAuto Keylock Call Melody Radio momentarily beeps as appears onTo deactivate keylock temporarily, press and hold To use monitor MonitorLevel Battery Level DisplayBattery Charge UHF Channels & Frequencies Optional Accessories AccessoriesAC Adaptor AAD-048 Desk Top Charger DTC-048 Speaker Microphone SM-048 Headset Microphone HM-048Transmitter GeneralReceiver Uniden UH-048XR UHF CB Radio WarrantyProcedure for obtaining performance or warranty Controls & Indicators External Mic/Speaker Page Page Uniden Australia Pty Limited/ Uniden New Zealand Limited