Uniden UBC 61XLT manual Chain Search, 460.0000 MHZ, 460.5000 MHZ, Setting a Search Range

To program a frequen- cy range into one of the five personal chain search bands, follow these steps:

1. Press SLCT until the search location you want appears in the display.

SLCT

Press

-OR-

• MANUAL to return to manual mode, or press to select the band you want to program.

If you attempt to turn off all personal chain search bands.

The error message turns off automatically and chain 1 is selected

when all search locations are empty.

SEARCH

1

000.0000 MHZ

CHAIN 1

UBC61 scanner Qk 3/12/02 11:22 AM Page 9

3.Press and hold PRI for two

seconds to desig- nate this channel as your new priority channel.

Two beeps indicate that the priority channel is changed.

• SCAN	1
• MANUAL	4
SRCH SLCT	7
HOLD	CLEAR
	•
LIGHT	WX

2

5

8

0

SKIP

L/O

3

6

9

E

PRI

2.Enter lower limit of the search band.

a)Enter the frequency number.

b)Then press

E

CHAIN 2

000.0000 MHZ

SEARCH

• SCAN	1	2	3
• MANUAL	4	5	6
SRCH SLCT	7	8	9
HOLD	CLEAR

P 4 460.4250 MHZ

HOLD PRI

Chain Search

Use chain search to find active frequencies in your area. You can search up to all five personal bands or turn off those bands you don’t want to hear. This gives you flexibility of searching for any channel between 66 and 512 MHz, as long as they are with- in the 8 frequency bands covered by the

UBC61XLT.

See the table on page 2

The display alternates

between the upper and lower ranges.

•	0	E
	SKIP
LIGHT WX	L/O	PRI

CHAIN 2

460.0000 MHZ

SEARCH

CHAIN 2

460.0000 MHZ

SEARCH

and

CHAIN 2

000.0000 MHZ

SEARCH

Setting a Search Range
An error message
displays when SRCH	CHAIN		2	ERROR MHZ
		2
is pressed and you				SEARCH
have not either
specified a search range in at least one chain
search band.

3.Enter upper limit of the search band.

a)Enter the frequency number

b)Then press

E

• SCAN	1	2	3
• MANUAL	4	5	6
SRCH SLCT	7	8	9
HOLD	CLEAR
	•	0	E
		SKIP
LIGHT	WX	L/O	PRI

CHAIN 2

460.0000 MHZ

SEARCH

• SCAN	1	2
• MANUAL	4	5
SRCH SLCT	7	8
HOLD	CLEAR
	•	0
		SKIP
LIGHT	WX	L/O

3

6

9

E

PRI

The display

alternates between the upper and lower ranges. If you program the wrong limit press

o and E then press o and E again to erase the error and reset the limits to zero.

Then begin again.

CHAIN 2

460.0000 MHZ

SEARCH

and

CHAIN 2

460.5000 MHZ

SEARCH

9