Uniden UBC3000XLT manual B80@@, Using Priority Scan, E3 3 07 @18@19, §EJ dFT§2O@

Using Priority Scan

You can program one Priority Channel in each

of the first 10 banks. During Priority Scanning, your scanner checks these special channels

every two seconds, whether or not the scanner has located an active channel.

To activate Priority Scanning:

11 12 13

Press 4(OSCAN) 6) @ @

14 15 18

(OIlAN~ @ @ @

0 ~ ~7 ~18~19~

~ ~ ~ ~

8FT 20

880@@

1112 13

(OSCAN) 6) @ @

14 15 18

(OIlAN~ @ @ @

BSAVE

E3 (3 07 @18@19

Press

§'EJ dFT(§)2O@

The scanner begins normal scanning, but if it detects a signal on a priority channel, it remains on that channel until the signal ends. See "Using Scan Delay" on Page 25.

lANK 1 U ~$it

SCAN

888SCAN

lANK li~l. 51

SCAN PRI

P ~ ~ 120.500 11Hz

12.5KHz All

Note: I~you have more than one bank selected that has a programmed priority channel, the lower channel number has top priority .

Data Skip is not active in this mode.

Selecting A New Priority Channel

There is one priority channel in each of the first 10 banks. The scanner is

pre-programmed with the first channel of each of these banks as a priority channel. However, you can change the priority

channel to be any other channel within the bank.

Note: When you select a new priority channel, the old priority channel automatically becomes a regular channel.

1.Enter the Manual Mode.

~1112 13

(OSCAN) 0 @ @

14 15 16

Press 4(OIlAN~ @ @ @

a ~ ~7 ~18~19

a~e;~~

8FT 20

B80@@

24