The Scan Mode
Begin Scanning
There are two ways to begin scanning.
. Turn on the scanner. Scanning begins each time you turn the UBC3000XL Ton.
. While in the Manual Mode:
11 12 13
Press 4(OSCAN) 6) @ @
14 15 16
(01lAN~ @ @ @
BSAVE 17 18 19
E380@@
8FT 20
B80@@
BANK I U ~$1t
SCAN DIo1'A"
888SCRn
In the Scan Mode, the UBC3000XL T cycles through all the channels you have
programmed in the banks that are currently active.
For more information see
-"Scanner Basics" on Page 7
-"Programming Channels" on Page 10
-"Turning Banks On or Off" on Page 20.
The scanner stops on each channel that is broadcasting a signal and automatically resumes scanning when the signal stops. Or, you can press (esCAN)tOresume scanning.
BANK 1I!'~4I'.,
SCAN
50 120.025 11Hz
12.5 KHz All
For more information see
-"Using Scan Delay" on Page 25
-"Using Data Skip" on Page 34
Turning Banks On Or Off
After you have programmed channels in several of the scanner's banks you can customise which channels you scan by turning the banks on or off.
1.
Press 4(0 SCAN) 01 @12 @13
( 0 IIAN~ @/ @15 @18
BSAVE
E38J 07 @18 @19
8FT 20
l3l30@@
BANK I 2 I c)$1t
SCAN DAWi '
888SCRn
20