Using Hold, Conference and Transfer
Transferring a Call
You can transfer a call from one handset to another. The handsets must be currently connected to the same base (see page 14).
. During a call, press [Int’com/clear].
2.Use [
] or [
] to select the handset you want to transfer the call to, and then press [Select/menu]. Select ALL to page all other handsets. The call will automatically be placed on hold, and a paging tone sounds. To cancel the transfer, press [
/flash] or [
].
3.When another handset accepts the transferred call, you will be disconnected. If you want to rejoin the call, press
[
/flash] or [
] again.
Answering a transferred call
When a handset receives a call transfer, it sounds a paging tone; handsets also show the ID of the handset that is paging. To accept the call transfer:
. To answer the page and speak to the transferring handset, press [
/flash] or [Int’com/clear].
Note: If AutoTalk is on, the handset will automatically answer the page when you pick up the handset from the cradle. If Any Key Answer is on, you can also press any key on the handset’s dial pad.
2.To accept the call and speak to the caller, press [
/flash] on the receiving handset.
3.When you accept the transferred call, the transferring handset will be disconnected.
Only the first handset to answer the transfer page will be connected to the call. If the transfer page is not picked up within one minute, the operation will be canceled.
39
DECT ELITE OM.indb 39
13/3/08 3:18:41 PM