Icom IC-F610 instruction manual Other Function, Call Back function, Dtmf function

DCall Back function

•If you do not want to answer the call immediately, use this function.

➥Pushing [Call Back] will allow you to enable or disable the function.

•When this function is enabled, the transceiver sends the Call Back to the called station. “CALL BACK” will be dis- played on the called station’s display, or, when you did not answer the call or the called station has cleared down before you answered the call while this function is dis- abled, the caller’s number is automatically retained in the memory.

•Up to 15 non-answered calls will be stored.

•When a call is received, the caller’s number is automati- cally retained in the memory.

•At the same time, starts blinking to tell the user that there is the non-answered call stored in the memory.

• will continue to blink until you have answered all the non-answered calls, or until you have cleared the memo- ry.

•When you push [Call Back] to confirm the memorized

contents, stops blinking.

•All the retained non-answered calls are cleared when the power is turned OFF.

Even if the Call Back function is enabled, calls can be made normally.

OTHER FUNCTION 4

•Call Back

qIf you push [Call Back] when the is blinking or lights,

the memory numbers are displayed.

wA memory number can be selected using [ ]/[]. e Select a number and then push [PTT]. The selected

number will be dialled to call back.

r The number called back will be deleted from the memo- ry.

t You cannot call back to any PSTN or PABX call. The calls are recorded only.

y To delete a memory number without calling back to that number, push [Call Back] and display the number using the Up and Down keys.

u Push the [Call Back] key for 2.5 seconds. The number will be deleted from the memory.

DDTMF function

This function allows you to send a DTMF code via the HM- 100TN (optional DTMF microphone) while still being able to communicate with the [PTT] switch on the traffic channel.

NOTE: Key pads of HM-100TN functions during standby mode as follows;

•0 to 9, ✱ and # for dialling.

•A: [P0], B: [P1], C: [P2] and D: [P3] of front panel.

16