Back Panel, HOW to Operate Your Transceiver

BACK PANEL

ANTENNA CONNECTOR: Connect a standard 50-ohm CB antenna to this connector.

EXT SP: When a speaker is connected to this jack the internal speaker is by-passed. All received signals will be heard through the external speaker. The speaker connected to the “EXT” jack should be rated at 8 ohms and 5 watts.

PA JACK An optional PA speaker may be attached to your transceiver through the PA output jack on the back panel. This allows you to communicate with pedestrians or other vehicles through your CB microphone.

DC 13.8V POWER JACK. Connects to power cord with in line 2 Amp fuse.

HOW TO OPERATE YOUR TRANSCEIVER

You should become familiar with the controls and complete the preceding installation instructions before attempting operation of your CB.

1.Rotate the on/off volume control clockwise to turn the unit on

2.Rotate the RF Gain control fully clockwise.

3.Adjust the squelch control fully counter-clockwise so noise is heard.

4.Adjust the volume for a normal listening level.

5.Rotate the squelch control until the noise just disappears. In some cases you may need to rotate the RF gain counter-clockwise to reduce the noise level.

6.Select the desired channel by rotating the channel selector.

7.To transmit press the PTT bar on the side of the microphone. Hold the microphone 2 to 3 inches from your lips and speak in a normal voice.

8.To receive simply release the PTT bar.

TECHNICAL SPECIFICATIONS
GENERAL
Frequency range	26.965-27.405 MHz
Channels	40
Modulation type	AM
Antenna impedance	50 Ohm
Loudspeaker	8 Ohm
Microphone ...............................................................................................…..Electret

BACK PANEL

HOW TO OPERATE YOUR TRANSCEIVER

TECHNICAL SPECIFICATIONS

GENERAL

8 Ohm