Cobra Electronics CXR825 owner manual Location, To change call settings Press the Mode button

Page 14
VibrAlert Only
Ring Only
VibrAlert + Ring
VibrAlert and Call Alert

Operation

Mode Functions

 

 

 

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

 

During memory location scan (while receiving an Incoming transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on that memory

Your microTALK radio can alert you to incoming signals by sounding an• audible call tone, by vibrating silently or both.

location.

b. Your radio will remain on that memory location and return to Standby mode. Press the Channel Up or Channel Down button to resume scanning memory locations.

c. After 10 seconds of inactivity, unit starts scan again.

If you press the Talk button while scanning, but more than

10 seconds after receiving a transmission, you will transmit on the memory location on which, during scanning, you last received a transmission.

If you do not press any button within 10 seconds, your radio will automatically resume scanning memory locations.

During memory location scan (while not receiving a transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on the channel/ privacy code that was displayed before you entered mode functions or memory location on which, during scanning, you last received a transmission.

b. Press the Mode button to proceed to other functions.

c. Press the Lock/Enter button to return to Standby mode

on the channel/privacy code that was displayed before you entered mode functions or the memory location on which, during scanning, you last received a transmission.

To reduce the number of memory locations being scanned, you may de-program any unwanted locations. (See page 16 to de-program a memory location.)

Mode Button

Channel Buttons

To change call settings:

1. Press the Mode button

until the Call Setting icon flashes on the display. The current setting (“01”

vibrate + ring, “02” vibrate only or “03” ring only)

is displayed.

2. Press the Channel Up or Channel Down button to change the call setting.

3. Choose one of the following:

a. Press the Mode button to enter the new setting and proceed to other functions.

b. Press the Lock/Enter button to enter the new setting and return to Standby mode.

22

23

Page 13 Page 15
Image 14
Page 13 Page 15
Contents For Assistance Outside the U.S.A Making Life Easier and SaferFor Assistance in the U.S.A Trademark Acknowledgement Product Features Warranty and Trademark AcknowledgementFeatures For products purchased in the U.S.A. and CanadaEstimated operation time on full charge 12 hours Avoid exposure to extreme temperaturesCaring for Your microTALK Radio Is on Using Your RadioTurning on Your microTALK Radio Listening for a Response Selectable HighMediumLow Power OutputChannels Call ButtonAuto Squelch/Maximum Range Lock FeatureSignal Strength Meter MicroTALK RangePrivacy Codes Mode FunctionsScrolling through Mode Functions To listen to All Hazards Radio channels Set DCS Privacy CodesThrough Selected, the display will flashVoice Activated Transmit VOX Memory LocationsTo recall a stored memory channel location Press the Mode button toBefore you entered mode functions While recalling a stored memory locationFlash on the display To de-program a memory locationChannel Scan To select the memory locationPrivacy Code Scan Location scan is on. Your radio will continue Memory Location ScanYour microTALK radio can automatically scan up to Radio will remain on that memory location for 10 secondsTo change call settings Press the Mode button LocationRoger Beep Confirmation Tone Call Tone SettingsKeystroke Tones Normal Position General Specifications FCC LicenseSafety Information for microTALK Radios If you have any questions about operation or installing Product ServiceProduct Service Questions For Products Purchased in the U.S.A
Top Page Image Contents