Cobra Electronics LI6700WX owner manual Choose one of the following, Press the Mode button to

Page 10

Mode Functions

Operation

6.Choose one of the following:

a.Press the Channel Up or Channel Down button to select a CTCSS privacy code (01 through 38) for the channel.

b.Press the Lock/Enter button to switch from CTCSS to DCS. The DCS icon and privacy code numbers will flash on the display. The Channel Up or Channel Down button can then be used to select a DCS privacy code (01 through 104) for the channel.

If “OFF” flashes in place of the privacy code numbers, a privacy code is already set in the opposite (CTCSS

or DCS) system. Press the Channel Up or Channel Down button to cancel the opposite code and select a privacy code from the active system for the selected channel.

7.Choose one of the following:

a.Press the Lock/Enter button to enter the channel/privacy code in the selected memory location. Radio then proceeds to next memory location, which will blink.

b.Press the Mode button to

enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.

c.Press the Talk button to enter the channel/privacy code in the selected memory location and exit mode functions. Upon release of the Talk button, the radio will enter Standby mode on the channel/privacy code just entered.

Introduction

Mode Button

Memory Icon

Channel Buttons

Operation

Customer Assistance

Warranty

To recall a stored memory channel location:

1.Press the Mode button until the Memory icon and the memory location number flash on the display.

2.Press the Channel Up or Channel Down button to select a memory location

(0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3.Press the Talk button to return to Standby

mode on the selected memory location.

A memory location can be reprogrammed at any time it is displayed. Press the Lock/Enter button to begin.

While recalling a stored memory location,

if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

14

15

Image 10
Contents Customer Assistance Operators Making Life EasierAutomated Help Desk QuestionsLimited One-Year Warranty on Radios & Charger Product Features Warranty TrademarkFeatures Backlit LCD Display For Products Purchased in the U.S.ACaring for Your microTALK Radio Avoid exposure to extreme temperaturesReplace battery compartment cover and belt clip Estimated operation time on full charge 12 hoursUsing Your Radio For charging microTALK radios in desktop chargerCall Button To alert another person that you are calling To switch from high to medium to low powerListening for a Response To Illuminate DisplayTo turn maximum range extender on Lock/Enter Button To turn the lock feature on or offLight/Max Range To briefly turn off auto squelch To attach a speaker/microphoneScrolling through Mode Functions Mode FunctionsPrivacy Codes Small numbers flash on the display Standby modeNOAA* All Hazards Radio Channels ThroughVoice Activated Transmit VOX Mode Button To turn VOX mode on or offMode Button To program a memory location Memory LocationsTo recall a stored memory channel location Press the Mode button toChoose one of the following While recalling a stored memory locationTo de-program a memory location Channel ScanPrivacy Code Scan Press the Mode button to proceed to set privacyPress the Channel Up or Channel Down button to Select Channel To scan privacy codesPress and hold the Talk button to communicate on Memory Location ScanTo scan memory locations To change call settings VibrAlert and Call AlertMode Button To change keystroke tones Mode Button To change a call tone settingTo turn roger beep on or off Safety Information for microTALK Radios General Specifications FCC LicenseGeneral Specifications Normal PositionProduct Service Questions Product ServiceFor Products Purchased in the U.S.A