Cobra Electronics PR3100DX owner manual Press and hold the Talk button to communicate on that

Page 10

Mode Functions

Operation

During Channel Scan (while receiving an incoming transmission), You Can Choose From The Following:

a. Press and hold the Talk button to communicate on that

Introduction

Operation

Customer Assistance Warranty

Privacy Code Scan

•

Your microTALK® radio can automatically scan the Privacy Codes (00 through 38) within one (1) channel.

channel. Your radio will remain on that channel and return to Standby mode.

b. Press the Channel Up or Channel Down button to resume scanning channels.

If you press the Talk button while scanning and not within ten (10) seconds of receiving a transmission, you will transmit on the channel on which you last received a transmission. This will return the radio to Standby mode.

If you do not press any button within ten (10) seconds, your radio will automatically resume scanning channels.

During Channel Scan (while not receiving a transmission), You Can Choose From The Following:

a. Press and hold the Talk button to communicate on the channel or channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning, you last received a transmission. This will return the radio

to Standby mode.

b. Press the Mode button to proceed to set privacy code scan on the channel that was either displayed before you entered mode functions or on which, during channel scanning, you last received a transmission (see page 15 for further details).

c. Press the Lock button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning, you last received a transmission.

Select Channel

Mode Button

Scan Privacy Codes

Channel Button

To Scan Privacy Codes:

1.While in Standby mode, press the Channel Up or Channel Down button to choose the channel on which you wish to scan privacy codes.

2.Press the Mode button until the Scan icon and the privacy code numbers flash on the display.

3.Press the Channel Up or Channel Down button to begin scanning privacy codes within the channel you selected.

The Scan icon will continue to be displayed when privacy code scan is On. Your radio will continue to scan privacy codes and stop as an incoming transmission is detected. Your radio will remain on that channel/privacy code for ten (10) seconds.

While setting privacy code scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code that was displayed before you entered mode functions.

14 English

Nothing comes close to a Cobra™ 15

Page 9 Page 11
Image 10
Page 9 Page 11
Contents PR 3100 DX Automated Help Desk Making Life Easier And SaferFor Assistance In The U.S.A Customer Assistance OperatorsBatteries To Install Or Replace Batteries Product FeaturesFeatures Caring For Your microTALK RadioUsing Your Radio To Switch From High To Low Power Volume To Adjust The VolumeSelectable HighLow Power Output Call ButtonSpeaker/Microphone Jack Scrolling Through Mode FunctionsSignal Strength Signal Strength Meter Speaker/Microphone To Attach Your Speaker/MicrophoneMode Functions Through To Recall a Stored Memory Channel LocationChannel Scan To De-Program a Memory LocationTo Scan Channels Privacy Code Scan Press and hold the Talk button to communicate on thatTo Scan Privacy Codes Memory Location Scan This will return the radio to Standby modeYou entered mode functions To Scan Memory LocationsChange the call setting To Change Call SettingsSetting vibrate + ring Vibrate only, or ring onlyPower Supply For Products Purchased In The U.S.A Licensing And ServiceProduct Service Questions For Products Purchased Outside The U.S.AOptional Accessories Warranty And AccessoriesLimited 1-Year Warranty Ordering From U.S.ACobra line of quality products includes
Top Page Image Contents