Cobra Electronics LI 3900DX owner manual Memory Locations, To program a memory location

Page 10

Mode Functions

Operation

10 Memory Locations

Your microTALK® radio has 10 Memory Locations for storing your most frequently used channels and channel/privacy code combinations. These Memory Locations can be selected individually or can be scanned. (See page 20 for memory location scan.)

Mode Button

To program a memory location:

 

1. Press the Mode button until the

 

Memory icon and the memory location

 

flash on the display.

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

6. Choose one of the following:

a. Press the Channel Up or Channel Down

button to select a CTCSS privacy code

(01 through 38) for the channel.

b. Press the Lock/Enter button to

switch from CTCSS to DCS. The DCS

icon and privacy code numbers will

flash on the display. The Channel Up

or Channel Down button can then be

used to select a DCS privacy code

Memory Icon

Channel Buttons

Lock/Enter Button

2.Press the Channel Up or Channel Down button to select the memory location (0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3.Press the Lock/Enter button to enter

a new memory location or edit an already programmed memory location. The channel numbers will flash on the display.

4.Press the Channel Up or Channel Down button to select a channel (1 through 22).

5.Press the Lock/Enter button.

The CTCSS icon and privacy code numbers will flash on the display.

(01 through 83) for the channel.

If “OFF” flashes in place of the privacy code numbers, a privacy code is already set in the opposite (CTCSS

or DCS) system. Press the Channel Up or Channel Down button to cancel the opposite code and select a privacy code from the active system for the selected channel.

7.Choose one of the following:

a.Press the Lock/Enter button to enter the channel/privacy code in the selected memory location. Radio then proceeds to next Memory location, which will blink.

b.Press the Mode button to

enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.

c.Press the Talk button to enter the channel/privacy code in the selected memory location and exit mode functions. Upon release of the Talk button, the radio will enter Standby mode on the channel/privacy code just entered.

12 English

Nothing Comes Close to a Cobra® 13

Image 10
Contents LI 3900DX Making Life Easier and Safer Product Features FeaturesCaring for Your microTALK Radio Avoid exposure to extreme temperaturesReplace battery compartment cover and belt clip Estimated operation time on full charge 10 hoursUsing Your Radio Listening for a Response When you are finished talking Selectable HighLow Power OutputTo toggle between high and low power Channels To select a channelTo turn the lock feature on or off Signal Strength Signal Strength MeterLock Feature Auto Squelch/Maximum RangePrivacy Codes Mode FunctionsScrolling through Mode Functions Set Ctcss Privacy CodesSet DCS Privacy Codes To turn VOX mode on or offStandby mode To select a DCS privacy codeMemory Locations To program a memory locationTo de-program a memory location To recall a stored memory channel locationWhile recalling a stored memory location While de-programming a memory locationTo scan channels Channel ScanFlash on the display Privacy Code Scan To scan privacy codesTo scan memory locations Press the Mode button to proceed to other functionsMemory Location Scan Number flash on the displayTo change a call tone setting Call Tone SettingsTo change call settings Press the Mode button untilGeneral Specifications Mode Functions General SpecificationsMode Button To change keystroke tones Keystroke TonesFCC License Product Service Product Service QuestionsWarranty and Trademark Acknowledgement Trademark AcknowledgementCobra line of quality products includes