Cobra Electronics LI7200WX To de-program a memory location, Channel Scan, To scan channels

Page 11

10293_LI7200WX_vB.qxd 9/5/07 10:55 AM Page 16

Operation

Mode Button

Mode Functions

To de-program a memory location:

1.Press the Mode button until the

Introduction

Operation

Customer Assistance Warranty

Channel Scan

Your microTALK® radio can automatically scan channels.

Memory Icon

Channel Buttons

Lock/Enter Button

Channel 0

Memory icon and the memory location flash on the display.

2.Press the Channel Up or Channel Down button to select the memory location (0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3.Press the Lock/Enter button. The channel numbers will flash on the display.

4.Press the Channel Up or Channel Down button to select Channel 0.

5.Choose one of the following:

a.Press the Lock/Enter button to enter the channel/privacy code in the selected memory location and return to the beginning of memory location options.

b.Press the Mode button to

enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.

While de-programming a memory location,

if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

Mode Button

Scanning Channels

Channel Buttons

To scan channels:

1.Press the Mode button until the Scan icon and the channel numbers flash on the display.

2.Press the Channel Up or Channel Down button to begin scanning channels.

The radio ignores specific privacy codes while scanning channels.

The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds.

While setting channel scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions.

16

17

Image 11
Contents Making Life Easier and Safer Trademark Acknowledgement Product FeaturesWarranty and Trademark Acknowledgement FeaturesEstimated operation time on full charge 12 hours Avoid exposure to extreme temperaturesReplace battery compartment cover and belt clip Caring for Your microTALK RadioPlug 120-volt adapter into electrical outlet Using Your RadioFor charging microTALK radios in desktop charger Insert radios into desktop charger as shownCall Button To alert another person that you are calling To switch from high to medium to low powerChannels Listening for a ResponseMicroTALK Range Lock FeatureSignal Strength Meter Auto Squelch/Maximum RangeSet Ctcss Privacy Codes Mode FunctionsScrolling through Mode Functions Privacy CodesNOAA* All Hazards Radio Channels Standby modeSet DCS Privacy Codes To select a DCS privacy codeMemory Locations Voice Activated Transmit VOXWhile recalling a stored memory location Press the Mode button toChoose one of the following To recall a stored memory channel locationTo scan channels To de-program a memory locationChannel Scan Select Channel To scan privacy codes Press the Mode button to proceed to set privacyPress the Channel Up or Channel Down button to Privacy Code ScanTo scan memory locations Memory Location ScanPress and hold the Talk button to communicate on VibrAlert and Call Alert To change call settingsRoger Beep Confirmation Tone Call Tone SettingsKeystroke Tones General Specifications General Specifications FCC LicenseProduct Service Questions Product Service