Cobra Electronics PR 255 VP Caring for Your microTALK Radio, To install or replace batteries

9508-PR255-2VP-D-FinalC #17 3/29/06 3:36 PM Page 1

Introduction Operation Customer Assistance Warranty

Caring for Your microTALK® Radio

•

Your microTALK® radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Remove Belt Clip Rechargeable Batteries
and Charger	•

Pull Up Lock Latch

To install or replace batteries:

1. Remove belt clip by releasing belt clip latch and sliding clip up.

2.Pull up on the battery door latch to

	remove the battery compartment cover.
	3. Insert the supplied four (4) AAA rechargeable
	batteries (also works with non-rechargeable
Insert Batteries
	alkaline batteries). Position batteries
	according to polarity markings.

4.Replace battery compartment cover and belt clip.

Radio Charger Jack To charge batteries in radio:

1.Check to see that the batteries have been inserted properly. See above for battery installation instructions.

2.Insert round connector of wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio. Non-rechargeable alkaline batteries can also be used.

Nothing Comes Close to a Cobra® 1