Cobra Electronics 150GTLDX owner manual 4Dim, 4NB/ANL / ANL / Off, 4Echo, 4Talk Back

Controls

Your Mobile Radio

Controls	•
- -
4RF Power Hi / Low
Places the transmitter in high power (15 watts) mode when the switch is in
the hi position and in low power (4 watts) mode when it is in the low position.
- -
4S/RF / SWR / CAL
When this switch is in the S/RF position, the display meter swings proportionally
to the strength of the signal received or the output power being transmitted.

When it is in the SWR position, the standing wave ratio is measured on the display meter.

When it is in the CAL position, the SWR function can be calibrated on the display meter by adjusting the SWR CAL control to move the needle to the calibration mark on the display meter face.

- -4Dim

Adjusts the NightWatch™ panel and meter brightness from min. to max. The antenna warning LED is not affected by this control.

- -4SWR CAL

This control is used in conjunction with the S/RF / SWR / CAL switch to calibrate the standing wave ratio circuit to full scale on the display meter in preparation for measuring the standing wave ratio that the antenna is presenting to the transceiver.

The standing wave ratio can be checked to insure that maximum power is being radiated for the longest signal range. The antenna must be in good condition, properly adjusted and matched to your transceiver. The SWR function of the display meter lets you easily measure your antenna condition. To operate this function, select a frequency near the middle of the range such as 28.850 MHz or the one you plan to use most. With the power on, set the S/RF / SWR / CAL switch to the CAL position. Press and hold the microphone Press-To-Talk button and, using the SWR CAL knob, adjust the meter to the CAL position indicated on the display meter. Then, while releasing the microphone button, switch the S/RF / SWR / CAL switch to the SWR position. Again press and hold the microphone Press-To-Talk button and read the SWR indicated. Lower figures are the better, with 1 being ideal. Generally, readings up to 3 are acceptable, but a reading greater than 3 indicates that you are losing radiated power and antenna adjustment may be advisable.

10 English

Controls

Your Mobile Radio

Controls	•
- -
4NB/ANL / ANL / Off
When this switch is in the ANL position, only the automatic noise limiter in the audio
circuits is activated. When the switch is placed in the NB/ANL position, the RF noise
blanker also is activated. The RF noise blanker is very effective for repetitive impulse
noise such as ignition interference. When the switch is in the off position, both the
noise blanker and the automatic noise limiter are disabled.
- -
4Echo
This control is used to adjust the output level of the echo circuit. It is also detented
at the fully counter clockwise position to turn off the echo circuit.
- -
4Talk Back
This control is used to adjust the desired amount of modulation talk back that is
present at the speaker during transmit.

Nothing comes close to a Cobra® 11