G
3.Applications:
Examples – System extensions – Product Recommendations
Adaptable lamps | ➔ Example for application: |
| Underwater lighting of water jets and pond edges. |
G
Avoid dry operation | Avoid dry operation of the pump as dry running will produce |
| undesirable heat and destroy the pump. |
5. Pump Maintenance
| ➔ Products: |
|
| GARDENA Underwater Light | Art. No. 7951 |
| GARDENA lightline Transformers |
|
Remote control | ➔ Example for application: |
|
| For operating water jets from the comfort of your patio or | |
| your living room. |
|
| ➔ Products: |
|
| GARDENA Remote Control Set | Art. No. 7874 |
| GARDENA Remote Control Socket | Art. No. 7875 |
Information |
| |
.Always unplug the pump first before working on it. | ||
| .Follow the Safety and Assembly Information attached to the | |
| operating instructions. |
|
|
|
|
4. Using the Pump for the First Time
Cleaning the pump and tank:
Removing dirt deposits from the pump:
The tank and pump must be free of dirt.
1.Unplug the pump from the mains.
2.Remove the pump from the water.
3.Rinse the pump and tank with a jet of water.
Information: Do not use any hard objects or strong detergents!
1. | Unplug the pump from the mains. |
2. | Remove the pump from the water. |
3. | Unscrew the hose clockwise from the threaded adapter. |
Pay attention to minimum water depth
Installing the pump:
Please note the maximum submersion depth (see “Technical Data”).
1.Place the pump in the tank.
2.Position the pump on a firm surface so that the upper edge of the basket is completely covered by water.
3.Screw the fountain onto the throttle valve.
4.Screw the fountain with throttle valve onto the pump.
4 3
2
4. Raise the pump slightly, twist and remove upwards. | |
5. | Screw the pump housing 1 anticlockwise as far as it |
1 | will go and remove (do not tilt). |
| |
6. | Pull the rotating unit 2 out of the motor housing 4. |
7. Remove all dirt deposits from the parts of the pump.
8.Insert the seal 3 into the groove of the motor housing 4.
9.Push the rotating unit 2 back into the motor housing 4.
10.Fit the pump housing 1 ensur-
ing that the threaded adapter is in a horizontal position and then screw the housing down (pay attention to the markings).
Adjusting fountain:
Water
Bell Cascade
Starting the pump
1.Screw the fountain insert you want to install (either Water Bell or Cascade) into fountain.
2.Screw throttle valve on pump
3.Only if installing Water Bell:
Screw Water Bell fountain insert into fountain until Waterbell creates the shape you want.
Connect the power cable to a 230 V AC socket.
A Caution! Pump will start running immediately!
6. Storing the Pump
Where to store | A The pump should be stored out of the reach of children. | |
| 1. | Remove the pump from the pond and store away from frost |
|
| before the first frost sets in. |
| 2. | Clean and check the pump carefully. |
| 3. | Store the pump in a container filled with water. |
|
| The mains plug must not be submerged. |
7. Trouble-Shooting
Blocked feed impeller | If the feed impeller becomes blocked, the pump and the filter |
| should be cleaned (see “Pump Maintenance”). |
| If you have any problems with your Pump, please contact our |
| Service. |
18 | 19 |