Audiovox FRS122-2 manual Installing the batteries

Page 6

3.Various Brands of Rechargeable Batteries - Use of the Audiovox charger with other brands of rechargeable batteries is not recommended, as battery charging times will vary with different brands of batteries. Refer to the manufacturer’s instructions for charging other brands of batteries.

Installing the batteries:

Battery installation is made more convenient when the carry clip is either rotated left or right to the horizontal position, or is removed. Simply rotate the clip in either direction to the horizontal position. Be careful not to use excessive force. To remove the clip, press down on the spring release tab and pull the clip straight out from the radio body. Next, press down with the thumb at the embossed arrow, slide the battery cover down and lift it away from the compartment. Insert four AAA batteries (alternate positive ends (+) toward the top of the transceiver, starting left-to-right.

CLIP SPRING

RELEASE TAB

CARRY

CLIP

BATTERY

COVER

 

COVER

 

ARROW

+ +

POSITIVE

 

TERMINALS

+

+

1.Using thumb, press down on battery cover at arrow and slide cover down.

2.Then lift cover at bottom to open. Remove cover.

6

3.Insert four AAA batteries (positive (+) end toward the top begining at left side and alternating positive terminals as shown).

128-6675

6 of 24

Image 6
Contents Model FRS122-2 Safety Information Model FRS122-2 Model FRS122-2DISPLAY Powering the transceiver Equipment and Accessories SuppliedOptional Accessories BatteriesInstalling the batteries MIC/CHG SP Jack Adapter Power Plug On or ControlsMonitor/Display Backlight Button Mode Button Operating Modes and Features Channel SelectionCtcss Mode Sub-Channel Selection Roger Beep Tone VOX Selection Mode Call Ringer Selection ModeButton Beep Key Tone Channel Scan Operation Battery Alert 128-6675 Troubleshooting Problem Possible cause CorrectionTechnical Specifications Main Channel Frequencies Continuous Tone Coded Squelch System Tone Frequencies in Hz Freq. Hz