KEY BEEP TONE SELECTION
The unit will emit a confirmation beep tone after a button has been pushed. To enable/disable the key beep tones, proceed as follows:
1.Perform the
2.With yes flashing, press the Function button twice; bep will appear with a flashing on or OFF indication.
3.Press the Up Button (8) or Down Button (12) to select the beep mode on or OFF as desired.
4.Press the Monitor (13) button to confirm your selection and return to the standby menu.
ROGER BEEP TONE SELECTION
The unit will transmit a beep tone sequence after each transmission to signal the receiving party that transmission has ended. This tone is called a “Roger Beep”. To enable/disable the Roger Beep tone, proceed as follows:
1.Perform the
2.With yes flashing, press the Function (F) button three times; rbp will appear with a flashing on or OFF indication.
3.Press the Up Button (8) or Down Button (12) to set the Roger Beep mode on or OFF as desired.
4.Press the Monitor (13) button to confirm your selection and return to the standby menu.
CHANNEL PRESET SELECTION
This feature allows you to preset up to three frequently used channel numbers, with their CTCSS channel designations, so that they can be quickly accessed without the need for selecting them individually through the normal channel/CTCSS selection process. To preset these channels, proceed as follows:
1.Perform the
2.With yes flashing, press the Function (F) button four times; a preset channel number in parenthesis (1, 2 or 3) will appear with a flashing channel number to the right. Press the Function button until (1) appears.
3.Press the Up Button (8) or Down Button (12) Up or Down button to select the desired channel number in the blinking display position.
4.Press the Enter ( 
) Button (9); the CTCSS position to the right flashes.
5.Press the Up Button (8) or Down Button (12) to select the desired channel for the tone code.
To set preset channels 2 and 3, repeat steps 1 through 5.
17